Home

The principle views associated with orthographic projection are ________.

A. Front view

B. Right side view

C. Top view

D. All of the above

Related Questions

  1. A partial auxiliary view usually shows only features on the ________ of the inclined line and not any…
  2. This should show what changes were made, when, and by whom:
  3. This is the intersection of the ground plane with the picture plane:
  4. These weld symbols have no arrow-side or other-side significance:
  5. It is customary for the first sheet of a working drawing set to include ________.
  6. In these drawings it is necessary to show cut surfaces and distinguish between adjacent parts:
  7. A typical set of mechanical working drawings includes ________.
  8. The ________ dimension tool will place the length of an angled line.
  9. When only a small section of an interior area needs to be revealed the drafter can use a ________ section.
  10. Drawings created with commercial software are typically saved as:
  11. The condition of a part when it contains the least amount of material is referred to as ________.
  12. These are accurately drawn maps of cities and towns showing property lines and other features that control…
  13. In working drawings, these show all necessary information not given directly on the drawing with its…
  14. To avoid having to dimension to a hidden feature the drafter can utilize a ________ section.
  15. An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
  16. Objects that are symmetric can be shown effectively using this type of section:
  17. This is the measured size of a finished part:
  18. Generally, the units used on an architectural drawing are set to ________.
  19. The typical parts list should include the ________.
  20. Architectural dimensioning is usually done in ________.
  21. A back or backing weld is a type of:
  22. Elevation drawings will include information about ________.
  23. This is the total amount that the feature on the actual part is allowed to vary from what is specified…
  24. Approximately this much of the cost of product development and manufacture is determined at the design…
  25. The building construction industry relies on sets of ________ drawings to construct homes and commercial…
  26. Newer versions of Auto-CAD utilize the ________ to make block library management very easy.
  27. In this type of section, one quarter of the object is removed:
  28. This type of projection is when projectors are parallel to each other, but is at an angle other than…
  29. These units are based on inch-foot and yard measurements:
  30. The bounding box method for setting up an isometric drawing helps the drafter ________.

Please do not use chat terms. Example: avoid using "grt" instead of "great".