Home

The radial distance of a tooth from the pitch circle to the bottom of the tooth is called

A. Dedendum

B. Addendum

C. Clearance

D. Working depth

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. For the same lift and same angle of ascent, a smaller base circle will give
  2. The number of centers in a crank driven slider crank mechanism is
  3. The frictional torque transmitted in a truncated conical pivot bearing, considering uniform pressure,…
  4. Governor is used in automobile to
  5. The working depth of a gear is the radial distance from the
  6. The maximum velocity of a particle moving with simple harmonic motion is
  7. The gear train usually employed in clocks is a
  8. In a flat collar pivot bearing, the moment due to friction is proportional to
  9. When two links are connected by a pin joint, their instantaneous centre lies
  10. The power from the engine to the rear axle of an automobile is transmitted by means of
  11. A pulley and belt in a belt drive form a
  12. If some links are connected such that motion between them can take place in more than one direction,…
  13. In steady state forced vibrations, the amplitude of vibrations at resonance is __________ damping coefficient.
  14. In a band and block brake, the ratio of tensions on tight side and slack side of the band is (where…
  15. In order to double the period of a simple pendulum, the length of the string should be
  16. The periodic time of one oscillation for a simple pendulum is
  17. TJIE horse power transmitted by a belt is dependent upon
  18. When a ship travels in a sea, which of the effect is more dangerous
  19. The mechanism forms a structure, when the number of degrees of freedom (n) is equal to
  20. Angle of action of cam is defined as the angle
  21. In order to give the primary balance of the reciprocating parts of a multi-cylinder inline engines,
  22. Which of the following is a higher pair?
  23. Critical damping is a function of
  24. The primary unbalanced force due to inertia of reciprocating parts in a reciprocating engine is given…
  25. In a cone pulley, if the sum of radii of the pulleys on the driving and driven shafts is Constant, then
  26. The maximum efficiency of spiral gears is (where θ = Shaft angle, and φ = Friction angle)
  27. In a Hartnell governor, the lift of the sleeve is given by (where r₁ and r₂ = Max. and…
  28. Klein's construction is useful to determine
  29. A shaft carrying two rotors at its ends will have
  30. For dynamic balancing of a shaft