Home

The refrigerant after condensation process is cooled below the saturation temperature before throttling. Such a process is called

A. Sub-cooling or under-cooling

B. Super-cooling

C. Normal cooling

D. None of these

Related Questions

  1. The air cooling system mostly used in transport type aircrafts is
  2. While designing the refrigeration system of an aircraft, the prime consideration is that the
  3. One of the purposes of sub cooling the liquid refrigerant is to
  4. In vapour compression cycle the condition off refrigerant is dry saturated vapour
  5. The condition of refrigerant after passing through the expansion or throttle valve, in a vapour compression…
  6. The wet bulb temperature during sensible cooling of air
  7. The temperature of air recorded by a thermometer, when its bulb is surrounded by a wet cloth exposed…
  8. For obtaining high COP, the pressure range of compressor should be
  9. A good refrigerant should have
  10. The coefficient of performance of Heat Pump is always __________ one.
  11. A one tonne refrigerating machine means that
  12. In aircraft, air refrigeration Cycle is used because of
  13. The C.O.P of a refrigeration cycle with increase in evaporator temperature, keeping condenser temperature…
  14. The material of pipe lines for a system using Freon as a refrigerant should be
  15. During humidification process, dry bulb temperature
  16. Highest pressure encountered in a refrigeration system should be
  17. The ratio of the actual mass of water vapour in a unit mass of dry air to the mass of water vapour in…
  18. The specific humidity during dehumidification process
  19. Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure,…
  20. The evaporator changes the low pressure liquid refrigerant from the expansion valve into
  21. Cooling water is required for following equipment in ammonia absorption plant
  22. The relative coefficient of performance is equal to
  23. The human body feels comfortable when the heat stored in the body is
  24. The leaks in a refrigeration system using Freon are detected by
  25. The lower horizontal line of the refrigeration cycle plotted on pressure-enthalpy diagram represents
  26. In chemical dehumidification process,
  27. In a refrigeration system, heat absorbed in comparison to heat rejected is
  28. The humidity ratio or specific humidity is the mass of water vapour present in
  29. A thermostatic expansion valve in a refrigeration system
  30. The suction pipe diameter of refrigerating unit compressor in comparison to delivery side is

Please do not use chat terms. Example: avoid using "grt" instead of "great".