Home

The rolling process cannot be used to produce

A. Plates

B. Rods

C. Tubes

D. Wires

Related Questions

  1. What is the range of tempering temperature (°C) for most of the materials?
  2. Minimum number of members required to form a Public Limited Joint Stock Com-pany is
  3. Pick out the wrong statement.
  4. Potable water means the water used for
  5. The co-ordination number in simple cubic structure is
  6. Thermal conductivity of a material does not depend upon its
  7. Which of the following processes follows the hardening process for reducing the hardening strains &…
  8. The malleability of a material is the property by virtue of which it can be rolled or hammered into…
  9. Which of the following is normally not found in both the S.I. (petrol) & C.I. (diesel) engines?
  10. Limestone addition in the blast furnace is done to flux __________ present in the raw materials.
  11. Spark plug is provided in a/an
  12. The critical pressure at which the latent heat of vaporisation of steam becomes zero is __________ Kg/cm2.
  13. The only suitable method for hardening the low carbon steel is case hardening. Which of the following…
  14. Laser is a device to produce
  15. Silicon percentage in silicon steel used for electrical equipments is about
  16. Electrostatic separation of minerals from each other is based on their differences in the following…
  17. Eutectoid composition of carbon steel at room temperature is
  18. Which of the following phenomenon/ phenomena is/are diffusion controlled?
  19. Volumetric composition of flue gas analysed with the Orsat apparatus is : CO2 = 12%, O2 = 8%, CO = nil,…
  20. Pick out the wrong statement.
  21. Which of the following metals is the most prone to work hardening?
  22. Tesla metre per ampere (T. m/A) is the unit for the measurement of
  23. The value of for air & most common gases can be safely assumed to be
  24. Electrometallurgical methods of metal extraction is normally used for those metals
  25. Unbreakable crockeries are made from __________ polymers.
  26. Case hardening of a material is
  27. Hot & cold working of material causes its __________ deformation.
  28. Which of the following is not a charge material for cupola?
  29. Lead is poured into the joints between two __________ pipes.
  30. The ratio of the shear stress to the principal stress on a principal plane is

Please do not use chat terms. Example: avoid using "grt" instead of "great".