Home
Current Affairs January 2024

What is the correct answer?

4

The shell diameter and length of locomotive boiler are

A. 1.5 m, 4 m

B. 1.5 m, 6 m

C. 1 m, 4 m

D. 2 m, 4 m

Correct Answer :

A. 1.5 m, 4 m


Related Questions

What is the correct answer?

4

Boiler H.P. is defined as the

A. Steam evaporation rate per kg of fuel fired

B. Work done in evaporating 1 kg of steam per hour from and at 100°C into dry saturated steam

C. The evaporation of 15.65 kg of water per hour from and at 100°C into dry saturated steam

D. Work done by 1 kg of steam at saturation condition

What is the correct answer?

4

In order to reduce the rotor speed of an impulse turbine, the method employed is

A. Velocity compounding

B. Pressure compounding

C. Pressure-velocity compounding

D. All of these

What is the correct answer?

4

Cut-off governing of steam engines is a method of controlling the engine output by varying

A. Volume of intake steam

B. Pressure of intake steam

C. Temperature of intake steam

D. All of these

What is the correct answer?

4

A condenser in a steam power plant

A. Increases expansion ratio of steam

B. Reduces back pressure of steam

C. Reduces temperature of exhaust steam

D. All of these

What is the correct answer?

4

The cylinder condensation or missing quantity may be reduced by

A. The efficient steam jacketing of the cylinder walls

B. Superheating the steam supplied to the engine cylinder

C. Keeping the expansion ratio small in each cylinder

D. All of the above

What is the correct answer?

4

In case of non-condensing steam engines, the pressure of steam in the cylinder during exhaust stroke is _________ the condenser pressure.

A. Equal to

B. Lower than

C. Higher than

D. None of these

What is the correct answer?

4

The pressure of reheat steam after passing through reheater compared to inlet condition is

A. More

B. Less

C. Equal

D. May be more or less depending on capacity of reheater

What is the correct answer?

4

The maximum steam pressure in a Locomotive boiler is limited to

A. 0.18 MN/m²

B. 1.8 MN/m²

C. 18 MN/m²

D. 180 MN/m²

What is the correct answer?

4

In a Woolf type compound engine, the high pressure and low pressure cylinders

A. Have common piston rod

B. Are set at 90°

C. Have separate piston rod

D. Are set in V-arrangement

What is the correct answer?

4

A closed vessel made of steel and used for the generation of steam is called a

A. Steam boiler

B. Steam turbine

C. Steam condenser

D. Steam injector

What is the correct answer?

4

Natural water circulation, by convection in water tube boilers, with increase in pressure of boiler

A. Increases

B. Decreases

C. Remain unaffected

D. First increases and then decreases

What is the correct answer?

4

A single acting steam engine produces ________ power than that of double acting steam engine.

A. Equal

B. Half

C. Double

D. Four times

What is the correct answer?

4

The function of injector used in small capacity boilers is to

A. Create vacuum

B. Inject chemical solution in feed pump

C. Pump water, similar to boiler feed pump

D. Add make up water in the system

What is the correct answer?

4

The major axis of elliptical manholes on the shell should be provided

A. Longitudinally

B. Circumferentially

C. On dished end

D. Anywhere

What is the correct answer?

4

Which of the following substance will have same percentage in both proximate and ultimate analysis?

A. Ash

B. Volatile matter

C. Moisture

D. Hydrogen

What is the correct answer?

4

Equivalent evaporation of water is the evaporation for a feed water supply at 100°C

A. And its corresponding conversion into dry saturated steam at 100°C and 1.033 kg/cm²

B. And its corresponding conversion into dry steam at desired boiler pressure

C. Conversion into steam at atmospheric condition

D. Conversion into steam at the same pressure at which feed water is supplied

What is the correct answer?

4

On Millier chart, the constant pressure lines

A. Diverge from left to right

B. Diverge from right to left

C. Are equally spaced throughout

D. First rise up and then fall

What is the correct answer?

4

The maximum discharge of steam through a convergent-divergent nozzle depends upon

A. Area of nozzle at throat

B. Initial pressure and volume of steam

C. Final pressure of steam leaving the nozzle

D. Both (A) and (B)

What is the correct answer?

4

In which of the following boilers, the draught in furnace is increased by utilising exhaust steam from engine

A. Lancashire boiler

B. Locomotive boiler

C. Babcock and Wilcox boiler

D. Benson boiler

What is the correct answer?

4

During storage, the heating value of coal

A. Increases

B. Decreases

C. Remain constant

D. May increase or decrease depending upon the method of storage

What is the correct answer?

4

Alkaline pyrogallate is used in Orsat's apparatus for absorption of

A. CO₂

B. CO

C. O₂

D. N₂

What is the correct answer?

4

When the inlet pressure of steam is equal to the exit pressure, then

A. There is a pressure drop in the nozzle

B. Fluid flows through the nozzle

C. Pressure drops and fluid flows through the nozzle

D. There is no pressure drop and fluid does not flow through the nozzle

What is the correct answer?

4

Mechanical equivalent of heat for 1 kcal or Joule's equivalent is equal to

A. 421 kg.m

B. 421 kg.m

C. 539 kg.m

D. 102 kg.m

What is the correct answer?

4

The safety valve on boiler drum compared to safety valve on superheater is set at

A. Same value

B. Higher value

C. Lower value

D. Lower/higher depending on steam flow

What is the correct answer?

4

In a reaction turbine, when steam flows through the fixed blades,

A. Pressure increases while velocity decreases

B. Pressure decreases while velocity increases

C. Pressure and velocity both decreases

D. Pressure and velocity both increases

What is the correct answer?

4

Which of the following statement is wrong?

A. The mechanical draught reduces the height of chimney.

B. The natural draught reduces the fuel consumption.

C. A balanced draught is a combination of induced and forced draught.

D. All of the above

What is the correct answer?

4

The reheat factor is the ratio of the

A. Cumulative heat drop to the isentropic heat drop

B. Isentropic heat drop to the heat supplied

C. Total useful heat drop to the total isentropic heat drop

D. None of the above

What is the correct answer?

4

In forced recirculation type boiler,

A. Heating takes place at bottom and the water supplied at bottom gets converted into the mixture of steam bubbles and hot water which rise to drum

B. Water is supplied in drum and through down comers located in atmospheric condition it passes to the water wall and rises to drum in the form of mixture of water and steam

C. Feed pump is employed to supplement natural circulation in water wall type furnace

D. Water is converted into steam in one pass without any recirculation

What is the correct answer?

4

Which of the following boilers is best suited to meet fluctuating demands?

A. Babcock and Wilcox

B. Locomotive

C. Lancashire

D. Cochran

What is the correct answer?

4

The average operating pressure of Benson boiler is

A. 100 bar

B. 150 bar

C. 200 bar

D. 250 bar