Related Questions
What is the correct answer?
4
The discharge of a depressed nappe is 6 to 7 percent __________ that of a free nappe.
What is the correct answer?
4
If the coefficient of discharge is 0.6, then the discharge over a right angled notch is
What is the correct answer?
4
For similarity, in addition to models being geometrically similar to prototype, the following in both cases should also be equal
A. Ratio of inertial force to force due to viscosity
B. Ratio of inertial force to force due to gravitation
C. Ratio of inertial force to force due to surface tension
D. All the four ratios of inertial force to force due to viscosity, gravitation, surface tension, and elasticity
What is the correct answer?
4
A hydraulic press has a ram of 15 cm diameter and plunger of 1.5 cm. It is required to lift a weight of 1 tonne. The force required on plunger is equal to
What is the correct answer?
4
Froude's number is the ratio of inertia force to
What is the correct answer?
4
In order to increase sensitivity of U-tube manometer, one leg is usually inclined by angle θ. Sensitivity of inclined tube to sensitivity of Utube is equal to
What is the correct answer?
4
The point at which the resultant pressure on an immersed surface acts, is known as
D. Centre of immersed surface
What is the correct answer?
4
The critical depth meter is used to measure
A. Velocity of flow in an open channel
B. Depth of flow in an open channel
What is the correct answer?
4
The tangential velocity of the water element having a free vortex is
A. Directly proportional to its distance from the centre
B. Inversely proportional to its distance from the centre
C. Directly proportional to its (distance)2 from the centre
D. Inversely proportional to its (distance)2 from the centre
What is the correct answer?
4
Specific weight of water in S.I. units is equal to
What is the correct answer?
4
The velocity of jet of water travelling out of opening in a tank filled with water is proportional to
What is the correct answer?
4
The discharge through a channel of circular section will be maximum when the depth of water is __________ the diameter of the circular channel.
What is the correct answer?
4
The pressure of the liquid flowing through the divergent portion of a Venturimeter
D. Depends upon mass of liquid
What is the correct answer?
4
The value of coefficient of discharge is __________ the value of coefficient of velocity.
What is the correct answer?
4
The value of mass density in kg-sec-V-m⁴ for water at 0°C is
What is the correct answer?
4
Euler's number is the ratio of __________ force to pressure force.
What is the correct answer?
4
Pressure of the order of 10 torr can be measured by
What is the correct answer?
4
A thick liquid like syrup has a __________ viscosity than a light liquid like water.
What is the correct answer?
4
The total pressure on a horizontally immersed surface is (where w = Specific weight of the liquid, A = Area of the immersed surface, and x = Depth of the centre of gravity of the immersed surface from the liquid surface)
What is the correct answer?
4
The pressure of a liquid measured with the help of a Piezometer tube is
What is the correct answer?
4
One poise is equal to
What is the correct answer?
4
The flow in a pipe is neither laminar nor turbulent when Reynold number is
What is the correct answer?
4
Practical fluids
B. Possess surface tension
D. Possess all the above properties
What is the correct answer?
4
A piece of wood having weight 5 kg floats in water with 60% of its volume under the liquid. The specific gravity of wood is
What is the correct answer?
4
For a body floating in a liquid the normal pressure exerted by the liquid acts at
A. Bottom surface of the body
D. All points on the surface of the body
What is the correct answer?
4
One stoke is equal to
What is the correct answer?
4
The hammer blow in pipes occurs when
A. There is excessive leakage in the pipe
B. The pipe bursts under high pressure of fluid
C. The flow of fluid through the pipe is suddenly brought to rest by closing of the valve
D. The flow of fluid through the pipe is gradually brought to rest by closing of the valve
What is the correct answer?
4
A weir is said to be narrow-crested weir, if the width of the crest of the weir is __________ half the height of water above the weir crest.
What is the correct answer?
4
For measuring flow by a Venturimeter, if should be installed in
C. Inclined line with flow downward
D. In any direction and in any location
What is the correct answer?
4
The most economical section of a trapezoidal channel is one which has hydraulic mean depth equal to
D. 1/4 × (depth + breadth)