Red colour
Yellow colour
Black colour
Blue colour
C. Black colour
Press load is reduced
Good cut edge is obtained
Warping of sheet is minimised
Cut blanks is straight
Simple die
Progressive die
Compound die
Combination die
Large electrode is used
Welding rod coated with slag is used
Welding rod coated with fluxing material is used
None of the above
Simple die
Progressive die
Combination die
Compound die
Cross filing
Draw filing
Pull and push filing
None of these
Smoothing and cleaning out depressions in the mould
Cleaning the moulding sand
Moistening the sand around the edge before removing pattern
Reinforcement of sand in the top part of moulding box
Cast iron
Mild steel
High speed steel
Cast tool steel
Continuous spot welding process
Multi-spot welding process
Arc welding process
Process used for joining round bars
Green sand
Dry sand
Loam sand
Oil sand
A cylindrical hole in a sheet of metal by the punch and the die
A hole (other than cylindrical) in a sheet of metal by the punch and the die
A flat sheet to the desired shape
A number of holes evenly spaced in a regular pattern on a sheet of metal
Camber on the rolls
Offset on the rolls
Hardening of the rolls
Antifriction bearings
Open air
A shielded gas environment
Vacuum
A pressurised inert gas chamber
Washing it with water
Rubbing on wood
Washing it with dilute acid
Using file card
Plunging
Notching
Slitting
Forming
3000°C to 4000°C
4000°C to 5000°C
5000°C to 6000°C
6000°C to 7000°C
Lower deviation is zero
Upper deviation is zero
Lower and upper deviations are zero
None of these
Low melting temperature
High melting temperature
Both (A) and (B)
None of these
Sand slinger
Squeezing machine
Jolt machine
Stripper plate machine
Is a two man saw
Is used for cutting along the grains of wood
Has a narrow blade with two wooden handles
All of the above
Deliver molten metal into the mould cavity
Act as a reservoir for the molten metal
Feed the molten metal to the casting in order to compensate for the shrinkage
Deliver the molten metal from pouring basin to gate
Only one operation is performed at each stroke of the ram
Two or more operations are performed simultaneously at the single stroke of the ram
Two or more cutting operations are performed at one station of the press in every stroke of the ram
Both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram
All pattern allowances
Only shrinkage allowance
All materials to be cast
All materials of the pattern
Direct current with straight polarity is used
Direct current with reversed polarity is used
Alternating current is used
Any one of these
Refining grain size
Reducing original block into desired shape
Controlling the direction of flow lines
All of these
Do not require bevelling
Should be bevelled to a single-V or U-groove
Should have a double-V or U-groove on one side
Should have a double-V or U-groove on both sides
Hot forging
Hot spinning
Hot extrusion
Hot drawing
Boring
Marking
Cutting
None of these
Shrinkage allowance
Machining allowance
Draft allowance
Distortion allowance
30°
45°
50°
60°
Punch
Die
Half on the punch and half on the die
Either on punch or die depending upon designer's choice