Home

The swift cup test evaluates the following property of a sheet metal.

A. Stretchability

B. Drawability

C. Bendability

D. None of these

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Main constituent of bone ash is
  2. The yield point phenomenon observed in annealed low carbon steel is due to the presence of the following…
  3. __________ pipe is the most suitable for carrying sanitary drainage.
  4. Hardening of steel is not possible, unless it is heated __________ critical point.
  5. Principal alloying element in Elinvar (used for making hair springs for watches) is
  6. What is the range of tempering temperature (°C) for most of the materials?
  7. Glycerine is used as a coolant in cooling of some engines instead of water, because
  8. Absolute zero pressure can be attained at a temperature of
  9. Increase in the entropy of a system represents the
  10. The value of for air & most common gases can be safely assumed to be
  11. If Reynolds number is greater than 1, then the
  12. Increasing the carbon content of steel
  13. The 'laughing gas' is
  14. Nuclear fission of one atom of uranium-235 produces the energy equivalent to about __________ MeV.
  15. A steam carrying pipeline is insulated with two layers of insulating materials with the inferior insulation…
  16. In the blast furnace, incorporation of water vapour in the blast gives the following effect.
  17. Boiling point of water gets lowered at high altitudes (e.g., hills), because
  18. Work required for compression of a gas contained in a cylinder is 7000 kJ. During compression, heat…
  19. Which of the following is not categorised as the ore agglomeration process?
  20. Screws are specified by their __________ diameters.
  21. Euler number is defined as the ratio of inertia force to __________ force.
  22. Which of the following materials has the least scrap value?
  23. On being hit with a hammer, __________ will readily fracture.
  24. Closeness of packing is maximum in case of __________ crystal lattice.
  25. Hydro-cyclone is a
  26. __________ is a non volatile film forming constituent of a paint.
  27. Two solutions A1 & A2 have pH value of 2 & 6 respectively. It implies that the solution
  28. Cold heading or upsetting is categorised as the __________ process.
  29. Tesla metre per ampere (T. m/A) is the unit for the measurement of
  30. High endurance limit of carburised machine parts is because of the fact that carburisation