Related Questions
What is the correct answer?
4
Cobalt - 60 is used as a source of __________ in medical therapy & industrial radiography.
What is the correct answer?
4
An oxidation process is accompanied with decrease in the
What is the correct answer?
4
Gantt charts are used for streamlining the
What is the correct answer?
4
Which of the, following is not associated with the functioning of a petrol engine?
A. Compression ignition system
What is the correct answer?
4
The __________ of a double acting reciprocating pump as compared to the single acting pump will be almost double.
What is the correct answer?
4
The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity.
What is the correct answer?
4
Which of the following is resistant to the action of both heat & chemicals?
What is the correct answer?
4
The cathode in an electrochemical cell always carries
D. Positive or negative charge depending upon the nature of the cell
What is the correct answer?
4
Aluminium is extracted from
What is the correct answer?
4
Production of a hollow product by inflation of a tube or parison is called the __________ process.
What is the correct answer?
4
Addition of __________ to steel does not help in improving its machinability.
What is the correct answer?
4
Use of flux during soldering is done to
A. Increase fluidity of solder by lowering its melting temperature
B. Prevent oxide formation
C. Wash away surplus solder
What is the correct answer?
4
__________ circuit is most commonly used to measure strain with the help of a strain gauge.
B. Voltage balancing potentiometric
C. Simple current sensitive
What is the correct answer?
4
Constituents of stellite are
B. Cobalt, chromium & tungsten
C. Zinc, aluminium & nickel
D. Nickel, cobalt & vanadium
What is the correct answer?
4
An abrupt and sudden fall in the reading of barometer is an indication of the
What is the correct answer?
4
At the point of boundary layer separation in fluid flow, the
A. Shear stress is maximum
B. Velocity gradient is flat
C. Density variation is maximum
What is the correct answer?
4
In Newton's law of viscosity, which states that the shear stress is proportional to the __________ Co-efficient of viscosity is called dynamic or absolute viscosity(where, V = velocity, = velocity gradient).
What is the correct answer?
4
Though tin occurs lower than iron in the electrochemical series, yet it is coated on steel for corrosion protection, because of its
C. Resistance to vegetable acids as the tin plate are commercially used in 'canning' industry
What is the correct answer?
4
The most important function of a washer is to provide bearing area and washers are normally specified by their hole diameters. The diameter of washer as compared to the nut is
D. More but less than the diameter of bolt
What is the correct answer?
4
Maximum consumption of limestone is in the __________ industry.
What is the correct answer?
4
The delivery pressure of boiler feed water pump compared to the boiler steam pressure is
What is the correct answer?
4
The activity co-efficient of the solute in a dilute solution
A. Decreases with the increase of concentration of the solute
B. Increases with the increase of concentration of the solute
D. Is unity at infinite dilution
What is the correct answer?
4
Most important property of steels for use in automobile bodies is the
What is the correct answer?
4
Which of the following is the most suitable material of construction for the condenser tubes, where the cooling medium is brine (salty water)?
What is the correct answer?
4
Consumable electrodes are used in the __________ welding.
What is the correct answer?
4
Lead pencil contains
What is the correct answer?
4
A reduction in thermal resistance during heat transfer does not occur in the
A. Convection heat transfer by stirring the fluid and cleaning the heating surface
B. Conduction heat transfer by reduction in the material thickness and increase in the thermal conductivity
C. Radiation heat transfer by increasing the temperature and reducing the emissivity
What is the correct answer?
4
Which of the following is not categorised as the ore agglomeration process?
What is the correct answer?
4
Density in the solid state is slightly less than that in its liquid state, in case of
What is the correct answer?
4
Magnetic permeability of iron is increased by its
D. Alternate heating & cooling