The universal gas constant (or molar constant) of a gas is the product of
Molecular mass of the gas and the gas constant
Atomic mass of the gas and the gas constant
Molecular mass of the gas and the specific heat at constant pressure
Molecular mass of the gas and the specific heat at constant volume
Also checkout these categories
Probability MCQ Development of Biology MCQ Races and Games MCQ Cause & Effect MCQ Alchohols MCQ Human reproductive system MCQ Design of Steel Structures MCQ Metabolism MCQ Heat & Mass Transfer MCQ Units, Dimensions and Errors MCQ Organic Chemistry MCQ Chemical Bonding and Molecular Structure MCQ
- When a body is subjected to biaxial stress i.e. direct stresses (σx) and (σy) in two mutually…
- In an extensive property of a thermodynamic system
- Steam coal is a
- Slenderness of a column is zero when
- When shear force at a point is zero, then bending moment is _________ at that point.
- The total elongation produced in a bar of uniform section hanging vertically downwards due to its own…
- The ratio of specific heat at constant pressure (cp) and specific heat at constant volume (cv) is
- For the same compression ratio, the efficiency of dual combustion cycle is
- The deformation of a bar under its own weight is _________ the deformation, if the same body is subjected…
- Charles' law states that all perfect gases change in volume by __________ of its original volume at…
- Tensile strength of a material is obtained by dividing the maximum load during the test by the
- Efficiency of a riveted joint is the ratio of its strength (max. load it can resist without failure)…
- When both ends of a column are fixed, the effective length is
- Diamond riveted joint can be adopted in the case of following type of joint
- For the beam shown in the below figure, the shear force diagram between A and B is
- In a tensile test, near the elastic limit zone, the
- The oxygen atom is ________ times heavier than the hydrogen atom.
- When it is indicated that a member is elastic, it means that when force is applied, it will
- Which of the following is an intensive property of a thermodynamic system?
- Which of the following is correct?
- The general law of expansion or compression is pvn = C, The process is said to be hyperbolic, if n is…
- Which of the following is a reversible non-flow process?
- The maximum diameter of the hole that can be punched from a plate of maximum shear stress 1/4th of its…
- Carnot cycle consists of
- The absolute zero pressure will be
- Which of the following statement is correct?
- The fuel mostly used in blast furnace for extracting pig iron from iron ores is
- The thickness of a thin cylindrical shell with hemispherical ends is __________ that of spherical ends.
- The absolute zero pressure can be attained at a temperature of
- For a perfect gas, according to Boyle's law (where p = Absolute pressure, v = Volume, and T = Absolute…