Home

Thermit welding uses the following energy source.

A. Electrical energy

B. Chemical energy

C. Energy of high velocity electrons

D. Heat generated by friction

Related Questions

  1. An oxidation process is accompanied with decrease in the
  2. A material subjected __________ must have high resilience.
  3. A compact estimate about the amount of materials handling between various work stations is obtained…
  4. The leaching solvent used in Baeyer's process for the purification of bauxite is
  5. Thermal efficiency of an internal combustion engine is around __________ percent.
  6. Which of the following is an unconventional source of energy?
  7. Brazing is the joining of metals
  8. Factor of safety is the ratio of the __________ stress to the working stress.
  9. Powder metallurgy is used to produce
  10. Which of the following forces does not act on a fluid at rest?
  11. __________ property of steel increases by addition of large amount of silicon in it.
  12. For which pair of the fuel gases, calorific value (C.V.) of one fuel is almost double that of the other…
  13. Melting point & boiling points of liquid oxygen are respectively - 218.8°C & - 183°C, while…
  14. Saturated steam at a pressure of 25 kg/cm2 is throttled to attain 5 kg/cm2. Then the outcoming steam…
  15. A solar cell converts the sunlight directly into __________ energy.
  16. In an eutectic system, two elements are completely
  17. As per the Indian boiler regulation (IBR), the type of joint preferred for the circumferential joint…
  18. The most important function of a washer is to provide bearing area and washers are normally specified…
  19. Capacity & power requirement for an air compressor working at high altitude compared to sealevel will…
  20. The most abundant metal present in the earth's crust is;
  21. To improve the machinability of steel, it is generally subjected to
  22. What is the range of tempering temperature (°C) for most of the materials?
  23. Energy to be supplied to the radioactive nucleus for the emission of a neutron is __________ MeV.
  24. Direct conversion of thermal energy to electrical energy is facilitated by the
  25. Alloying elements present in Haynes stellite, which has superior performance than high speed steel,…
  26. Volume of blast furnace slag is about __________ times the volume of hot metal (pig iron) of the same…
  27. Blasting of tri-nitro-toluene (TNT) is done by mixing it with ammonium
  28. The approximate height of a blast furnace having a useful volume of 2000 m3 is about __________ metres
  29. One face of a furnace wall is at 1030°C and the other face is exposed to room temperature (30°C).…
  30. Quartz is a __________ material.

Please do not use chat terms. Example: avoid using "grt" instead of "great".