Home

These gears transmit power between shafts whose axes intersect at any angle:

A. Worm gears

B. Spur gears

C. Bevel gears

D. Racks

Related Questions

  1. This is the bottom surface joining the sides of two adjacent threads:
  2. This is formed where three or more surfaces intersect:
  3. Two-point perspective is also known as:
  4. The Auto-CAD command used to combine two or more primitive shapes into a single complex 3-dimensional…
  5. The UCS icon represents the intersection of the ________.
  6. This is used in drawings to represent the edge of a solid object:
  7. A round is a rounded surface on the ________ corner of a part.
  8. Which of the following is one of the basic types of welded joints:
  9. 5.These items typically are not used in new designs, but are still common in high-power amplifiers:
  10. When setting up a mechanical drawing in Auto-CAD the drafter should set the units to ________.
  11. The site plan illustrates ________.
  12. In an oblique drawing, equally spaced partial circles may be used to show this:
  13. How can the drafter prevent Auto-CAD from placing or stacking another center mark on a circle when adding…
  14. Perspective drawings are classified according to their number of these features:
  15. Most architectural firms and mechanical design companies utilize different categories of blocks. These…
  16. Approximately this much of the cost of product development and manufacture is determined at the design…
  17. Given a situation in which the drafter has crossed extension lines in a drawing what can be done to…
  18. This material is used in masonry construction, most commonly for ornamental facing:
  19. Center lines are used to locate or represent the centers of ________.
  20. This should show what changes were made, when, and by whom:
  21. In this type of drawing, vertical pipes may be revolved into the horizontal plane:
  22. If designs require changes, they should be documented with:
  23. Drawings created with commercial software are typically saved as:
  24. In the section view, the areas that would have been in actual contact with the cutting plane are shown…
  25. These types of pipes are generally connected with bell and spigot joints or flanged joints:
  26. In this type of section, one quarter of the object is removed:
  27. If a plane is parallel to the plane of projection, it appears:
  28. This type of solid has a polygon for a base and triangular lateral faces that intersect at a vertex:
  29. When creating a Cutting Plane line with Auto-CAD it is customary to use a ________ to create the line.
  30. A fillet is a rounded surface on the ________ corner of a part.

Please do not use chat terms. Example: avoid using "grt" instead of "great".