This means that a feature of a finished product contains the maximum amount of material permitted by the tolerance dimensions for that feature:
Maximum material condition
Machined material condition
Maximum machined indication
Machine mark indication
- 4.The principle reason for using an auxiliary view is ________.
- These plans, made by the steel fabricator, are assembly drawings for the steel structure:
- When using the descriptive geometry method to create an auxiliary view the drafter should __________.
- In multi-view drawing it is common practice to include three views, the front, the top and the right…
- This allows the designer to conceptualize objects more easily without having to make costly illustrations,…
- This type of solid is formed by sweeping a shape along a linear path:
- On typical electronic diagrams, these items need not be shown unless they are needed for clarification:
- Architectural dimensioning is usually done in ________.
- The text used on a typical detail sheet should be ________.
- The maximum and minimum sizes of a feature are identified by a ________ tolerance.
- This is a conical-shaped recess around a hole, often used to receive a tapered screw head:
- These gears transmit power between shafts whose axes intersect at any angle:
- In architectural drawing ________ are often used to illustrate and detail structural components.
- Approximately this much of the cost of product development and manufacture is determined at the design…
- An accurate record of changes made to release drawings is tracked via this:
- A circular arc is dimensioned in the view where you see its true shape by giving the value for its:
- Some of the common terms used to describe technical drawing include:
- This is used in drawings to represent the edge of a solid object:
- The Offset tool should only be used for placing ________ in an isometric drawing.
- Which of the following is one of the basic types of welded joints:
- A secondary auxiliary view is a projection off of the ________.
- This is the smallest diameter of a screw thread:
- The architectural and construction industries use the United States National CAD standard (NCS) system…
- The 3-D commands on the Modeling toolbar include ________.
- In order to set drawing limits for a C size architectural drawing the drafter should set the limits…
- A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
- This type of section is limited by a break line:
- In this type of concrete, the steel is pre-tensioned before the superimposed load is applied:
- Objects that are symmetric can be shown effectively using this type of section:
- This type of structural steel drawing shows all dimensions necessary for fabrication: