Home

This process recognizes the inherent interrelationships between design and manufacturing:

A. Design for manufacture

B. Design for manufacture and assembly

C. Design for concurrent engineering

D. Design for assembly

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The thread note for a typical bolt will include the ________.
  2. This allows the performance of structures to be analyzed and tested efficiently, accurately, and quickly:
  3. This type of rapid prototyping system uses a laser to fuse powdered metals, plastics, or ceramics:
  4. These weld symbols have no arrow-side or other-side significance:
  5. The dimension text size is determined by what the architect deems necessary in __________.
  6. Oblique sections are useful to show this:
  7. A cylinder can be created by drawing a rectangular shape then the ________ tool.
  8. This material is used in masonry construction, most commonly for ornamental facing:
  9. These maps are used in planning installations of trees, shrubbery, drives, and other garden features:
  10. The Free Orbit tool is found on the ________ toolbar.
  11. When drawing a line using the relative coordinate system a line is created from ________.
  12. These plans, made by the steel fabricator, are assembly drawings for the steel structure:
  13. In this type of concrete, the steel is pre-tensioned before the superimposed load is applied:
  14. In this type of section, one quarter of the object is removed:
  15. In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
  16. This is the smallest diameter of a screw thread:
  17. An oil refinery relies on which type of drafter to maintain and update the technical piping drawings…
  18. This is the term for the range of tightness or looseness resulting from the allowances and tolerances…
  19. Several of the tools used in traditional drafting include the following:
  20. This type of surface may be a plane, a single curved surface, or a warped surface:
  21. Given a situation in which the drafter has crossed extension lines in a drawing what can be done to…
  22. The ________ tool on the Dimension tool bar places the length of an arch on a drawing.
  23. When using versions of Auto-CAD prior to Release 2006 it may be necessary to ________ a block in order…
  24. When creating a Cutting Plane line with Auto-CAD it is customary to use a ________ to create the line.
  25. When creating a block the drafter needs to pay particular attention to selecting a base point because…
  26. A partial auxiliary view usually shows only features on the ________ of the inclined line and not any…
  27. This line pattern is composed of three dashes, one long dash on each end with a short dash in the middle:
  28. In order to create an isometric circle to represent a hole through the top surface of a box, the drafter…
  29. This is the measured size of a finished part:
  30. Architectural dimensioning is usually done in ________.