Home

This type of section is limited by a break line:

A. Removed section

B. Revolved section

C. Broken-out section

D. Half section

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate…
  2. Switches and relays should be shown in this position with no operating force or applied energy:
  3. When designing a home for a client, one of the most important predesign considerations that an architect…
  4. On typical electronic diagrams, these items need not be shown unless they are needed for clarification:
  5. Approximately this much of the cost of product development and manufacture is determined at the design…
  6. Dimensions are used on the elevation plan to describe ________.
  7. In order to set drawing limits for a C size architectural drawing the drafter should set the limits…
  8. The site plan illustrates ________.
  9. One critical issue drafters need to pay close attention to is the ________.
  10. The organized and orderly approach to solving problems is known as the:
  11. These plans, made by the steel fabricator, are assembly drawings for the steel structure:
  12. This is the total amount that the feature on the actual part is allowed to vary from what is specified…
  13. EDM is the acronym for:
  14. Some common blocks used by architectural drafters include ________.
  15. The maximum and minimum sizes of a feature are identified by a ________ tolerance.
  16. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
  17. The Offset tool should only be used for placing ________ in an isometric drawing.
  18. A partial auxiliary view is used to show only the ________ in the auxiliary view.
  19. 9.The lines used to create the auxiliary view should appear as ________ in the finished view.
  20. A back or backing weld is a type of:
  21. This is a rounded exterior blend between surfaces:
  22. It is customary for the first sheet of a working drawing set to include ________.
  23. Auto-CAD refers to isometric ellipses as ________.
  24. The ________ tool on the Dimension tool bar places the length of an arch on a drawing.
  25. This is used in applications for nonferrous construction:
  26. This type of drawing is created to calculate areas, locate property lines, and locate building projects…
  27. The MASSPROP shortcut will provide the following information.
  28. This type of drawing shows two lines representing the pipe diameter:
  29. Drafters should use a ________ in a section view of a mechanical part that includes the cylindrical…
  30. This type of auxiliary view is projected onto a plane that is perpendicular to one of the principal…