This type of solid is egg-shaped and can be created by revolving an ellipse around one of its axes:
Ellipsoid
Torus
Cone
Cylinder
- The ________ tool on the Dimension tool bar places the length of an arch on a drawing.
- This is used in applications for nonferrous construction:
- This type of axonometric drawing has equal foreshortening along two axis directions and a different…
- Architectural dimensioning standards allow for the placement of dimensions inside the floor plan. These…
- Some traditional board drafters preferred the drafting machine over the parallel straight edge because…
- In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
- Some common blocks used by architectural drafters include ________.
- An accurate record of changes made to release drawings is tracked via this:
- When the drafter types the word BLOCK or selects the Make Block tool from the Draw tool bar the ________…
- In the mechanical design process the first step is to ________.
- The condition of a part when it contains the least amount of material is referred to as ________.
- This is the smallest diameter of a screw thread:
- This line pattern is composed of three dashes, one long dash on each end with a short dash in the middle:
- This type of structural steel drawing shows all dimensions necessary for fabrication:
- This type of surface may be a plane, a single curved surface, or a warped surface:
- Before starting an isometric drawing in Auto-CAD the drafter needs to ________.
- These are accurately drawn maps of cities and towns showing property lines and other features that control…
- Which of the following is one of the basic types of welded joints:
- These units are based on inch-foot and yard measurements:
- In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
- These are joined together in the field to build a structure:
- When the receding lines are true length, and the projectors are at 45 degrees to the plane of projection,…
- In oblique sketches, the most commonly used angles for receding lines are:
- In a CAD system, you can draw an ellipse by specifying these:
- Some of the common terms used to describe technical drawing include:
- When dimensioning architectural drawings architects will utilize both ________ and ________ options.
- Center lines are used to locate or represent the centers of ________.
- Some of the standard Auto-CAD text styles used in architectural drawings includes ________.
- The Offset tool should only be used for placing ________ in an isometric drawing.
- When filling an area with a hatch pattern in Auto-CAD the drafter needs to be able to ________.