Home

To recall a previous command, which of the following would you use?

A. CTRL-P

B. ctrl-n

C. ctrl-r

D. down arrow

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Which of the following is false concerning OSPF?
  2. The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a…
  3. The dialer map command contains all of the following parameters except __________.
  4. Which Frame Relay command is used to manually resolve addresses?
  5. Which control sequence moves the cursor to the end of the line?
  6. You are given a class C network and you have four LAN segments with the following numbers of devices:…
  7. Which is not one of the three main functions of a layer-2 device?
  8. Which IGRP command allows unequal-cost load balancing?
  9. A _________ uses Gigabit Ethernet as a media type
  10. Which protocol supports VLSM?
  11. A ___________ is basically all of the components, hardware and software, involvedin connecting computers…
  12. When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt…
  13. Which metric components, by default, are used in IGRP? (Choose all the correct answers.)
  14. If you enter a command in either User EXEC mode or Privilege EXEC mode that the IOS does not recognize,…
  15. A _________ is used to connect networking devices that are in a very close geographic area, such as…
  16. _________ defines how the Frame Relay DTE and DCE interact with each other.
  17. If you wanted a list of parameters for the show command, you would type ________.
  18. An _____________ is a public IP address associated with an inside device.
  19. You are given the following addressing information: 172.17.16.255/23. What type of address is this?
  20. The _______ program goes out and finds the IOS and loads it.
  21. Extended IP ACLs should be placed as close to the ____________ device as possible.
  22. _________ has a physical star topology but a logical ring topology.
  23. A __________ route is the best path to reach a destination within the topology table.
  24. What would you enter to see the last few commands you entered?
  25. On the 1900 switch, how do you enter User EXEC mode?
  26. You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol…
  27. Which is true concerning a port in a listening state? (Choose all correct answers.).
  28. The switch port that is chosen to forward traffic for a segment is called a __________.
  29. Which of the following is false concerning CHAP?
  30. Which of the following is a disadvantage of SANs?