Home

Two-point perspective is also known as:

Share latest video status. Download from playstore now!

A. Two-view perspective

B. Regular perspective

C. Parallel perspective

D. Angular perspective

Share this question with your friends

Correct Answer : D.


Download Objective type questions of Engineering Drawing PDF

Get all objective type questions of Engineering Drawing MCQ

Related Questions

  1. This is used in drawings to represent the edge of a solid object:
  2. When positioning this feature of perspective projection, the centerline of the cone of visual rays should…
  3. In the section view, the areas that would have been in actual contact with the cutting plane are shown…
  4. In some circumstances an entire drawing can be inserted into a different drawing as a block. When this…
  5. The Conceptual Visual Style tool is located on the ________ toolbar.
  6. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
  7. A line drawn with a long section, short dash, and another long section is a ________.
  8. Acceptable parts must not extend beyond this:
  9. An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
  10. PDM is the acronym for:
  11. The section view drawing in which one fourth of an object has been marked for removal is known as a…
  12. This is the total amount that the feature on the actual part is allowed to vary from what is specified…
  13. Students can complete an associate's degree in drafting which normally takes about ________ years to…
  14. An architect often relies on a ________ to complete the set of technical drawings used in the design…
  15. The top, front, and bottom views align in this manner:
  16. In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
  17. Circular shapes appear in this fashion when viewed at an angle other than 90 degrees:
  18. In the mechanical design process the first step is to ________.
  19. This is the theoretically exact size from which limits of size are determined:
  20. The UCS icon represents the intersection of the ________.
  21. A round is a rounded surface on the ________ corner of a part.
  22. If a designer is developing a plan for a project in which the entire part is made out of ¾ thick…
  23. These plans, made by the steel fabricator, are assembly drawings for the steel structure:
  24. This type of solid is egg-shaped and can be created by revolving an ellipse around one of its axes:
  25. These drawings are given to contractors to perform work or manufacture individual parts:
  26. In isometric projection, all distances are approximately this percentage of their true size:
  27. The Offset tool should only be used for placing ________ in an isometric drawing.
  28. Placement of dimensions on a drawing is controlled by ________.
  29. Lines of an isometric drawing that are not parallel to the isometric axes are called this:
  30. Schematic and single-line diagrams should be arranged so that signal or transmission path from input…

Please do not use chat terms. Example: avoid using "grt" instead of "great".

Submit
Load More..

Also checkout these categories

Rearrangement Set 5 MCQ Gymnosperms MCQ Decimal Fraction MCQ Data Sufficiency MCQ Tumors of the testes MCQ Upper urinary tract trauma MCQ Drawing Inference MCQ Solution MCQ Rearrangement Set 14 MCQ Thermodynamics MCQ Digestive System MCQ Operating System MCQ