Two single runways may be arranged so as to have
L-shape
T-shape
X-shape
All the above
Correct Answer :
D. All the above
Related Questions
The landing and takeoff of the air craft is made against the direction of wind. In no case the centre line of the runway should make an angle with the wind direction exceeding
10°
20°
30°
40°
According to the International Civil Aviation Organisation (I.C.A.O.) the strength of runway pavements, have been coded by
Seven English alphabets
Last Seven English alphabets
First Seven English alphabets
First seven numbers
For determining the basic runway length, the landing case requires that aircraft should come to a stop within p % of the landing distance. The value of p is
40 %
50 %
60 %
75 %
Pick up the correct abbreviation from the following:
L.M.M. (low powered middle marker)
V.H.F, (very high frequency)
L.O.M. (low powered outer marker)
All the above
According to the International Civil Aviation Organisation (I.C.A.O.), the runway lengths of aerodromes, have been coded by
Seven English alphabets
Last Seven English alphabets
First Seven English alphabets
First seven natural numbers
The length of runway under standard conditions is 2000 m. The elevation of airport site is 300 m. Its reference temperature is 33.05°C. If the runway is to be constructed with an effective gradient of 0.25 percent, the corrected runway length will be
2500 m
2600 m
2700 m
2800 m
The reduced levels of the ends A and B of a runway are 3025 m and 3035 m and that of its mid-point is 3015 m. The reduced level of the horizontal surface, is
3070 m
3060 m
3075 m
3015 m
Two single runways may be arranged so as to have
L-shape
T-shape
X-shape
All the above
In instrument landing system
L.O.M. and L.M.M. are installed on one side and Localizer antenna on the other side
L.O.M. and Localizer are installed on one side and L.M.M. on the other side
Localizer and L.M.M. are installed on one side and L.O.M. on the other side
None of these
The fuse large includes
Passengers chamber
Pilot's cabin
Tail of aircraft
All the above
Pick up the component not applicable to aeroplanes
Wings
Engines
Air screw
None of these
In approach areas of runways equipped with instrumental landing facilities any object within 4.5 km distance from runway end shall be considered as an obstruction if its height is more than
20 m
30 m
45 m
51 m
The main disadvantage of angle nose out parking configuration of aircraft is that the
Aircraft rear loading door is far away from terminal building.
Hot blast is directed towards the terminal building
Overall apron area required is more
All the above
The total length of a runway is 1000 m. The elevation at distance 0,200 m, 400 m, 600 m, 800 m and 1000 m are 100.0 m, 99.2 m, 101.0 m, 101.8 m, 101.4 m and 101.0 m respectively. The effective gradient of runway will be.
0.10 %
0.26 %
0.43 %
0.65 %
Effective length of a runway is the distance between
Ends of the runway
Point of intersection of the obstruction clearance line and the extended plane of the runway surface, and the other end of the runway
Point of intersection of the glide path and the extended plane of the runway surface and the other end of the runway
Ends of the clear way on either side
Pick up the correct statement from the following:
Approach zone survey is carried out to determine the elevations of the protruding obstructions above horizontal, conical and transitional surfaces
The wind data of an air port is depicted in the form of a chart known as wind rose
The landing and takeoff of the air craft is made against the wind direction
All the above
For night landing, the thresholds are lighted
Green
Red
White
Yellow
As per ICAO recommendation, minimum width of safety area for instrumental runway should be
78 m
150 m
300 m
450 m
Speed of
Sound at 0°C is 1190 kmph
Sound varies 2.4 kmph per degree centigrade rise in temperature
Sound at 0°C is called one Mach
All the above
The minimum width of clearway is
50 m
100 m
150 m
250 m
Pick up the incorrect statement from the following:
L.O.M. is installed at 7.2 km from the threshold
L.M.M. is installed at 1.0 km from the threshold
Localizer antenna is installed at 300 m from the other end of the runway
Glide slope antenna is installed at the centre of the runway about 150 m on one side
Pick up the correct statement from the following:
Approximate geometric centre of the landing area, is called air port reference point
The boundaries of horizontal surface and conical surface are marked with reference to air port reference point
The location of the air port on a map is the position of air port reference point
All the above
The cruising speed of the aircraft is 500 kmph. If there is a head wind of 50 kmph, then the air speed and ground speed of the aircraft respectively will be
450 kmph and 500 kmph
500 kmph and 450 kmph
450 kmph and 450 kmph
500 kmph and 500 kmph
The length of runway is increased per 300 m rise above M.S.L.
3 %
4 %
5 %
7 %
According to ICAO, all markings on the runways are
Yellow
White
Black
Red
Pick up the incorrect statement from the following:
Channelization of pavement is caused by constant use of tri-cycle gears of aircraft
Blast pads are used over cohesionless soils to resist erosion due to tremendous speed of the jet blast
Over-run areas of at least 300 m length on either side of the runway are provided
None of these
If the monthly mean of average daily temperature for the hottest month of the year is 25°C and the monthly mean of the maximum daily temperature of the same month of the year is 46°C, the airport reference temperature is
32°C
35.5°C
48°C
25°C
The threshold markings are
4 m wide
1 m clear space between adjacent
Placed symmetrically on either side of the runway centre line
All the above
The maximum length and pavement strength of the runway is that of
A 1
B 2
B 3
G 7
The air is blowing at a speed of 75 knots in the direction of the aircraft flying at a ground speed of 775 knots. The air speed of the aircraft, is
775 knots
75 knots
850 knots
675 knots