Related Questions
What is the correct answer?
4
The minimum carbon content in steel should be __________ percent for it to respond to a hardening treatment.
What is the correct answer?
4
The difference between gross & net calorific values of fuel is due to the
A. Sensible heat carried away by the flue gases
B. Heat carried away by the steam from the moisture content of the fuel
C. Heat lost by radiation
D. Heat carried away by steam from the combustion of hydrogen in the fuel
What is the correct answer?
4
The most important function of a washer is to provide bearing area and washers are normally specified by their hole diameters. The diameter of washer as compared to the nut is
D. More but less than the diameter of bolt
What is the correct answer?
4
Pick out the correct statement about the condensation.
A. Filmwise condensation gives a lower heat transfer rate than the dropwise condensation
B. Suitable coating or vapour additive is used to promote film wise condensation
C. If a condensing liquid does not wet the surface dropwise, even then condensation will take place on it
D. Reynolds number of condensing liquid is based on its mass flow rate
What is the correct answer?
4
The unit of gc is
What is the correct answer?
4
The boiling & freezing points on a newly defined temperature scale in degree 'D' are 400°D & 100°D respectively. The temperature reading corresponding to 60°C on this new temperature scale will be equal to __________ °D.
What is the correct answer?
4
Moist air is cooled along the line of constant __________ , when it is passed over a cold & dry cooling coil, such that no condensation occurs?
What is the correct answer?
4
Oxyacetylene reducing flame is used while carrying out welding on
What is the correct answer?
4
Angular displacement can be measured suitably by a
B. Linear variable differential transducer (LVDT)
What is the correct answer?
4
Induced draft fans provided in large thermal power plant boilers have __________ blades.
What is the correct answer?
4
Holes for riveting purposes should be preferably made by
What is the correct answer?
4
The specific gravity of coal depends mainly on its __________ content.
What is the correct answer?
4
Steel containing low percentage of nickel, chromium & tungsten are termed as the __________ steel.
What is the correct answer?
4
Probability of cavitation occuring becomes very high, when the local __________ resulting in water bubbles formation, which on rupture cause cavitation
A. Pressure falls below the vapour pressure
B. Pressure becomes very high
C. Temperature becomes low
What is the correct answer?
4
Sub zero treatment of steel is done to
A. Suppress martensite transformation
B. Enhance its working performance in sub zero atmosphere
C. Reduce the retained austenite in hardened steel
D. Induce temper brittleness after its hardening
What is the correct answer?
4
In connection with corrosion of metals, passivation is the process that
A. Intensifies deterioration
B. Changes the composition of the metal
C. Inhibits further deterioration
What is the correct answer?
4
Optical activity is a/an __________ property.
What is the correct answer?
4
The majority charge carriers in p-type silicon are
What is the correct answer?
4
Wrought iron does not have
A. Uniform strength in all directions
B. Ability to hold protective coating
C. High ductility & corrosion resistance
D. Easily weldable characteristics
What is the correct answer?
4
The materials which fracture even at small strains are termed as brittle, while those materials which exhibit an appreciable deformation before failure are termed as
What is the correct answer?
4
The same volume of all gases is representative of their
C. Gas characteristic constants
What is the correct answer?
4
The laminar boundary layer thickness in zero pressure gradient flow over a flat plate along the x-direction varies as x0.5 while the thickness of turbulent boundary layer varies as (where, x = distance from the leading edge)
What is the correct answer?
4
The most prominent single cause of corrosion in boiler-tubes, drums, economisers and steam superheaters in a thermal power plant boiler is the
A. Water alkalinity & leakage
B. Hydrazine addition during feed water treatment
C. Release of non-condensable gas from water in the boiler
What is the correct answer?
4
The most suitable material of construction for a sewer to carry sewage under high pressure is
What is the correct answer?
4
Nickel and __________ are the alloying element added in steel to increase its toughness.
What is the correct answer?
4
Which of the following is an undesirable property of slag produced during the Pyrometallurgical method of metal extraction from its ore?
A. High fusibility & fluidity
B. High thermal conductivity
D. High chemical activity
What is the correct answer?
4
A material being tested for endurance strength is subjected to the __________ load.
What is the correct answer?
4
Suitability of steel for its use in cable is judged by its strength in
What is the correct answer?
4
Corona discharge is related to the operation of a/an
B. Electrostatic precipitator
D. Magneto hydrodynamic generator (MHD)
What is the correct answer?
4
In case of compression of one kg of air, the work done will be the least, when the value of polytropic index 'n' is