Related Questions
What is the correct answer?
4
Which interface type is used to connect to the serial interface of a router?
What is the correct answer?
4
When configuring a router-on-a-stick, the configuration is done on __________.
What is the correct answer?
4
How would you suspend a telnet session?
What is the correct answer?
4
An _____________ is a public IP address associated with an inside device.
A. Inside global IP address
B. Inside local IP address
C. Outside global IP address
D. Outside local IP address
What is the correct answer?
4
Which type of traffic is not flooded?
What is the correct answer?
4
_________ defines how the Frame Relay DTE and DCE interact with each other.
What is the correct answer?
4
Extended traceroute works from which mode?
D. User and Privilege EXEC
What is the correct answer?
4
BPDU stands for ____________.
A. Bridge Protocol Description Unicast
B. Bridge Protocol Data Unit
C. Bridge Protocol Description Unit
D. Bridge Protocol Data Unicast
What is the correct answer?
4
A routing protocol that supports route summarization must perform all except which of the following?
A. Carry the subnet mask with the network entry.
B. Make routing decisions based on the entire destination IP address.
C. Summarize entries so that the same lowest-order bits match.
What is the correct answer?
4
Which of the following is the most expensive type of WAN connection?
A. Dedicated circuit connection
B. Circuit-switched connection
C. Packet-switched connection
What is the correct answer?
4
EIGRP uses the _________ algorithm to update its routing table.
What is the correct answer?
4
Which control sequence moves the cursor to the end of the line?
What is the correct answer?
4
What router command saves the active configuration to NVRAM?
A. copy nvram startup-config
B. copy startup-config running-config
C. copy running-config nvram
D. copy running-config startup-config
What is the correct answer?
4
What must you do to enable IP routing on your router? (Choose all of the correct answers.)
A. Enable the routing protocol.
B. Set clocking on all serial interfaces.
C. Assign IP addresses to your router's interfaces.
D. Assign the bandwidth parameter to your serial interfaces
What is the correct answer?
4
Which router command would you use to view the configuration register value?
What is the correct answer?
4
The _________ command takes you from User EXEC mode to Privilege EXEC mode
What is the correct answer?
4
Which 2950 command enables trunking?
What is the correct answer?
4
You are given a class C network, 192.168.1.0/24. You need one network with 120 hosts and three networks with 60 hosts. What subnet mask values would you use?
A. 255.255.255.128 and 255.255.255.192
What is the correct answer?
4
Which of the following is not an advantage of DHCP?
A. It allows for the use of private addressing.
B. It reduces the amount of configuration on devices.
C. It reduces likelihood of configuration errors.
D. It gives you more control by centralizing IP addressing information.
What is the correct answer?
4
PPP can do all of the following except ___________.
What is the correct answer?
4
RIP generates routing updates every _________ seconds.
What is the correct answer?
4
On the 1900 switch, how do you enter User EXEC mode?
A. It comes up by default.
B. Enter the letter U in the menu.
C. Enter the letter K in the menu.
D. Enter the letter C in the menu.
What is the correct answer?
4
A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain information for a user.
What is the correct answer?
4
Which of the following is true concerning 802.1Q?
A. It supports hub connections.
B. It is supported on both the 1900 and 2950 switches.
C. The native VLAN is tagged.
D. The original Ethernet frame is not modified.
What is the correct answer?
4
During the learning function, the switch places addresses and ports in a(n) _________ table.
What is the correct answer?
4
You are given a Class C network with 25 bits of networking. How many subnets do you have?
What is the correct answer?
4
What would you use to prevent a packet from traveling around a routing loop forever?
What is the correct answer?
4
Which Frame Relay command is used to manually resolve addresses?
A. frame-relay interface-dlci
What is the correct answer?
4
If the 2950's RPS is ________, the external power supply is supplying power.
What is the correct answer?
4
_________ allows you to create this summarization: 10.0.0.0/7.