Home

What command creates a DHCP address pool on a router?

A. ip dhcp

B. ip pool dhcp

C. ip dhcp pool network

D. ip dhcp pool

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. If the port status LED on a 2950 is ________, there is a physical layer connection problem.
  2. _________ allows you to create this summarization: 10.0.0.0/7.
  3. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  4. Which of the following is the most expensive type of WAN connection?
  5. VLSM allows a network segment to have more than one subnet mask.
  6. When choosing a networking product, you should consider all of the following except _______.
  7. Annex A is which LMI standard?
  8. Private addressing is defined in RFC ______.
  9. Which types of memory do not maintain their contents during a power-off state?
  10. Which interface type is used to connect to the serial interface of a router?
  11. RIP supports load balancing for up to __________ ___________ paths.
  12. During the learning function, the switch places addresses and ports in a(n) _________ table.
  13. Which command takes you from Privilege EXEC mode to User EXEC mode?
  14. 172.16.240.256 is a class __________ address.
  15. A ___________ is basically all of the components, hardware and software, involvedin connecting computers…
  16. You are in Interface Subconfiguration mode and want to completely return to Privilege EXEC mode. What…
  17. You are given a class C network and you have four LAN segments with the following numbers of devices:…
  18. IGRP generates an update every ___________ seconds.
  19. The router automatically saves its configuration.
  20. What command activates the IP routing process?
  21. You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
  22. Which VTP mode(s) will propagate VTP messages?
  23. IOS images can be loaded from all the following except:
  24. If you enter a command in either User EXEC mode or Privilege EXEC mode that the IOS does not recognize,…
  25. When you have configured PPP on an interface and use the show interfaces command, what state indicates…
  26. The ___________ converts an ISDN four-wire connection to a two-wire connection.
  27. You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol…
  28. Choose the following that a standard IP ACL can match on.
  29. You are given a class C network, 192.168.1.0/24. You need three networks with 60 hosts and two networks…
  30. When connecting a router to a PC, use a __________ cable.