Home

What is the percentage of chromium in 18-4-1 high speed steel?

A. 1

B. 4

C. 18

D. 23

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Heating the Hypo-eutectoid steels to 30°C above the upper critical temperature line, soaking at…
  2. Which of the following is the correct nature of shear stress distribution along the cross section in…
  3. If a nuclear reactor produces more fissile nuclear fuel than it consumes, then it is called a __________…
  4. The taper provided on pattern for its easy & clean withdrawal from the mould is termed as the __________…
  5. Chlorine acts as a bleaching agent only in the presence of
  6. Dislocations are __________ defects.
  7. The most commonly used moderator in nuclear power plants is
  8. Large diameter reinforced cement concrete (RCC) pipes are generally joined by __________ joint.
  9. The stress at which extension of the material takes place more rapidly as compared to the increase in…
  10. Brazing is the joining of metals
  11. Specific gravity of a metal, which weighs 5 kg in air and 4 kg when submerged in water, will be
  12. A spring material should have low
  13. Pick out the wrong statement about nucleate boiling.
  14. The temperature at which the magnetic property of iron disappears (i.e., it becomes non-magnetic) and…
  15. Thermal conductivity of a material does not depend upon its
  16. The underground well of a biogas plant is called the
  17. Bad odour in sanitary latrines is reduced by periodically sprinkling
  18. The usual energy consumption in electric arc furnace steel making is __________ KWh/ton of steel.
  19. Routing in production, planning & control is concerned with the
  20. During decarburising of a plain carbon steel, the thickness of ferrite layer growth is proportional…
  21. Filler material used in welding should have __________ as compared to the parent metal to be welded.
  22. With increase in annealing temperature, the following defect density decreases.
  23. Nusselt number is related to Grashoff number (Gr) in turbulent & laminar flow respectively, in respect…
  24. For efficient performance of a blast furnace, the extent of reduction of Wustite (FeO) should be
  25. Wave length of X-rays is about 1 angstrom; however it cannot pass through a sheet of
  26. Blast furnace slag is mainly molten
  27. The minimum temperature to which the water can be cooled in a cooling tower is the __________ temperature…
  28. Moist climate is the most favourable factor in the site selection far a
  29. For the Stoke's law to be valid in the case of a falling sphere in a fluid, the
  30. Annealing of white cast iron produces __________ iron.