What is the resonant frequency of a circuit when L of 25 microhenrys and C of 10 picofarads are in parallel?
10.1 kHz
10.1 MHz
101 MHz
101 kHz
Correct Answer :
B. 10.1 MHz
Related Questions
In a rectangular wavea the peak factor is
The average value of a triangular or sawtooth wave is _____ times its peak value.
Which of the following is not considered a physical factor affecting resistance?
Length
Material type
Temperature
Cross-sectional
Which of the following is a preferred resistor value?
43a000
54a321
What is the rms value of a square wave?
Equals its peak value
Equals its peak-to-peak value
Peak divided by square root of two
Peak divided by pi
When voltage is applied across a ceramic dielectric the electrostatic field p roduced is 50 times greater than air dielectric. The dielectric constant of ceramic therefore is
What is the value of a carbon composition resistor with the following color code: Browna whitea orangea red
190 ; 10 %
19 k ; 2 %
19 k ; 20 %
1.9 k ; 2 %
The impedance in the study of electronics is represented by resistan
Inductance
Capacitance
Inductance and capacitance
Reactance
Electron flow assumes charges flow from
Negative to positive
Negative to negative
Positive to negative
Positive to positive
Which one of the following elements serves as a protection against overload?
Fuse
Switch
Resistor
Relay
Which of the following is a way of decreasing mutual inductance?
Moving the coils closer
Moving the coils apart
Decreasing the number of turns of either coil
Increasing the number of turns of either coil
What is a closed path made of several branches of the network called?
Junction
Node
Terminal
Loop
In a circuita an active element is one which
Supplies energy
Receives energy
Both supplies and receives energy
Amplifies signal
The farad is not equivalent to which of the following combination of units
CV2
C2/J
C/V
J/V2
Which of the following dielectric materials makes the highest-capacitance capacitor?
Air
Barium-strontium titanite
Mica
Electrolyte
Inductive reactance applies only to sine waves because it
Increases with lower frequencies
Increases with lower inductance
Depends on the factor 2
Decreases with higher frequencies
What is the peak factor for alternating current or voltage varying sinusiodally?
A factor that states how much the resistance changes for a change in temperature?
Resistivity
Specific resistance
Coefficient of temperature change
Temperature coefficient of resistance
A capacitor requires 12 C of charge to raise its potential of 3 V. What is the capacitance of the capacitor?
36 F
15 F
0.25 F
4 F
If the inductance is decreaseda the impedance of the circuit containing a resistor a capacitor and an inductor connected in series to an ac source
Decreases
Increases
Decreases or increases
Decreasesa increases or remains the same
In dividing or multiplying phasor quantitiesa ___ form is used.
Polar
Rectangular
Trigonometric
Exponential
At what frequency will an inductor of 5mH have the same reactance as a capacitor of 0.1 F?
7.12 kHz
7.12 Hz
7.12MHz
7.12 GHz
An open inductor has
Zero resistance and infinite inductance
Infinite resistance and zero inductance
Infinite resistance and infinite inductance
Zero resistance and zero inductance
A capacitance of 0.05 F equals
0.05 x 106F
0.05 x 10-6F
0.05 x 10-12F
0.05 x 1012F
If resonant frequency is 10 kHz and quality factor is 50a then
Bandwidth is 200 Hz
XL= is 50a000
R is 50
XC= is 50a000
What is the most convenient way of achieving large capacitance?
By using multiplate construction
By using air as dielectric
By decreasing distance between plates
By using dielectric of low permittivity
A series RLCcircuit consists of a 10 resistor in series with L = 10 Ha and C= 100 F. Determine a new value of Ia for which the resonant frequency is one ±half the original value.
40 H
40 mH
40 pH
40 nH
Of the equivalent combination of unitsa which one is not equal to watt?
2/V
AV
A2
J/s
The value of temperature coefficient ( ) is dependent upon
The nature of material and temperature
The length of material
The cross-sectional area of the material
The volume of the material
A trigger circuit consisting of a capacitor of 0.01 F is connected in series with a resistor. If the circuit requires 100 Vdcto operatea determine the value of the resistor when time constant is 0.009s.
900 k
900 M
900 G