What is the specific resistance of a pure germanium?
55 -cm
55 -m
55 -mm
55 k -m
Correct Answer :
A. 55 -cm
Related Questions
What is the other name of relative permittivity?
Dielectric strength
Potential gradient
Breakdown voltage
Specific inductance capacity
If one resistance in a series connection is opena then
The current is zero in all the other resistances
The current is maximum in all the other resistances
The voltage is zero across the open resistance
The voltage is infinite across the open resistance
What value of R is needed with a 0.05 F Cfor an RCtime constant of 0.02 s?
400 M
400 G
400 k
In the 5-band method of capacitor color codinga the first band indicates
Temperature coefficient
Tolerance
1stdigit
Capacitance value
The current is ____ times the maximum current at half-power points of a resonance curve.
When voltage is applied across a ceramic dielectric the electrostatic field p roduced is 50 times greater than air dielectric. The dielectric constant of ceramic therefore is
According to Gauss theorema flux can be equated to
Charge
Field intensity
Current
Voltage
For maximum power transfera what is the relation between load resistance RL and internal resistance R of the voltage source?
RL= 2 r
RL= 1.5 r
RL= r
RL= 3 r
What is the total effective capacitance of two 0.25 F capacitors connected in series?
0.125 F
1.25 F
0.50 F
2.5 if
The farad is not equivalent to which of the following combination of units
CV2
C2/J
C/V
J/V2
Series resonant circuit is sometimes known as
Rejector circuit
Acceptor circuit
Inductive circuit
Capacitive circuit
High resistance values are a consequence of the ___ of the film.
Thickness
Length
Thinness
Area
The charging of a capacitor through a resistance follows what law?
Linear law
Hyperbolic law
Inverse-square law
Exponential law
What theorem is usually used in the analysis of transistor circuit?
Superposition theorem
Millman�s theorem
Thevenin�s theorem
Norton�s theorem
Which of the following is a way of decreasing mutual inductance?
Moving the coils closer
Moving the coils apart
Decreasing the number of turns of either coil
Increasing the number of turns of either coil
A three-by-threea series-parallel matrix of resistorsa all having the same ohmic valuea would have a net resistance of
One-third the value of a single resistor
Three times the value of a single resistor
The same value as a single resistor
Nine times the value of a single resistor
Points to be considered in choosing a capacitor
Working voltage
Type of dielectric
Capacitance
All of the above
If three 100-pF capacitors are connected in seriesa then the total capacitance is
300 pF
100 pF
50 pF
33.3 pF
If the inductance is decreaseda the impedance of the circuit containing a resistor a capacitor and an inductor connected in series to an ac source
Decreases
Increases
Decreases or increases
Decreasesa increases or remains the same
When the power factor of a circuit is zeroa
Power absorbed is maximum
Power absorbed is minimum
Power absorbed is zero
The impedance is minimum
In an ac circuita the power dissipated as heat depends on
Impedance
Capacitive reactance
Resistance
Inductive reactance
A series RL circuit has R of 10 and XL of 5 a its impedance in rectangular form is given by
10 +j 5
10 + j 10
10 ± j 5
10 ± j 10
In a circuita an active element is one which
Supplies energy
Receives energy
Both supplies and receives energy
Amplifies signal
In a resonant circuita if Q ? 10 resonant frequency _______ bandwidth.
Bisects
Exceeds
Is less than
Is equal to
The ratio between the reactive power and the apparent power of an ac load is called
Quality factor
Power factor
Power ratio
Reactive power
The ___ of an alternating quantity is defined as the fractional part of a period or cycle through which the quantity has advanced from selected origin.
Phase
Frequency
Amplitude
Waveform
What is the reading of an ohmmeter for a shorted capacitor?
Zero
Infinity
k
M
In liquids and gasesa ionization current results from a flow of
Positive or negative ions
Free electrons
Ions that are lighter in weight than electrons
Protons
The superposition theorem is used when the circuit contains
Reactive elements
Active elements
Number of voltage sources
Single voltage source
What is the form factor of a triangular wave?