Home

What is the specific resistance of a pure silicon?

A. 55 -mm

B. 55 -m

C. 55 -cm

D. 55 k -m

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Nortons theorem is ____ Thevenins theorem.
  2. Which of the following has a positive temperature coefficient?
  3. The farad is not equivalent to which of the following combination of units
  4. The power factor of a certain circuit in which the voltage lags behind the current is 80 %. To increase…
  5. What is the efficiency under the conditions of maximum power transfer?
  6. Inductive reactance applies only to sine waves because it
  7. What is the form factor of a triangular wave?
  8. A switch designed to have low capacitance between its terminal when open.
  9. According to Gauss theorema flux can be equated to
  10. The presence of an electric current is made known by
  11. Which component opposes voltage change?
  12. Which of the following materials has the lowest dielectric strength?
  13. What is the time constant for L of 240 mH in series with R of 20 ?
  14. For a triangular and sawtooth waveform the rms voltage or current equals
  15. What refers to the lowest voltage across any insulator that can cause current flow?
  16. Parallel resonant circuit is sometimes called as
  17. The reason why electrical appliances are connected in parallel.
  18. With double the number of turns by the same length and areaa the inductance is
  19. What is the rms value of a square wave?
  20. The capacitance of a capacitor is ___ relative permittivity.
  21. When current and voltage arte in phase in an ac circuita the ___ is equal to zero.
  22. The Q-factor of a series resonant circuit is also known as
  23. The ratio of the flux density to the electric field intensity in the dielectric is called
  24. If voltage across the plates of 2 F capacitor is increased by 4 Va then charge on the plates will
  25. The ratio between the reactive power and the apparent power of an ac load is called
  26. Effects of capacitance
  27. What theorem is usually used in the analysis of transistor circuit?
  28. For a series ACcircuita ___ is not used as a reference phasor.
  29. In calculating maximum instantaneous power ___ voltage or current is used.
  30. When two in-phase sine waves that have identical frequency and amplitude are added togethera then the…