Working voltage

Surge voltage

Stray voltage

Peak voltage

**A series RLCcircuit has a ______ power factor at its half-power points****If two resistances of 9 and 6 are connected in parallela the total resistance is****A capacitance of 6 µµF means****What is the rms value of a square wave?****If two complex conjugates are addeda ___ components results.****A coil of inductance L has an inductive reactance of XLin an ac circuit in which the effective current…****Rationalizing the denominator of a complex number means****In calculating maximum instantaneous power ___ voltage or current is used.****The average value of a triangular or sawtooth wave is _____ times its peak value.****The reason why alternating current can induce voltage is****Which of the following is not a factor affecting dielectric strength?****Which of the following is the most popular waveform?****For a linear circuita ___ voltage or current is used to calculate average power.****Refers specifically to steady state values of quantities in ac circuits which are complex numbers.****Effects of capacitance****A wire of one kilometre length has a resistance of 20 . If the length is halveda then the new resistance…****If the output resistance of a voltage source is 4 a it internal resistance should be****The result of rust in electrical (wire) connection is****For a carbon composition resistora typical resistance values range from****Which of the following combination of length and cross-sectional area will give a certain volume of…****A neon glow lamp used as a night light ionizes at approximately****What does a capacitor store?****An inductive load always has a ___ power factor****What is the complex impedance of a circuit with an absolute resistance of 300 ?****If two equal resistances connected in series across a certain supply are now connected in parallel across…****Tungsten filament of bulbs has a hot resistance higher than its cold resistance due to its temperature…****Which of the following materials has the lowest dielectric strength?****A real current source has****For maximum power transfera what is the relation between load resistance RL and internal resistance…****A capacitor requires 12 C of charge to raise its potential of 3 V. What is the capacitance of the capacitor?**