Related Questions
What is the correct answer?
4
Which router command would take you back to a suspended telnet session?
What is the correct answer?
4
What would you use to prevent a packet from traveling around a routing loop forever?
What is the correct answer?
4
Which would you use to move your cursor back one word?
What is the correct answer?
4
OSPF hellos are sent every __________ seconds on a multi-access medium.
What is the correct answer?
4
When a carrier experiences congestion, it marks the _______ bit in the header of the Frame Relay frame.
What is the correct answer?
4
When choosing a dynamic routing protocol, which of the following should not be considered?
B. How routing information is shared
C. How routing information is processed
D. Number of PCs in the network
What is the correct answer?
4
Which router command would you use to test only layer-3 connectivity?
What is the correct answer?
4
During the learning function, the switch places addresses and ports in a(n) _________ table.
What is the correct answer?
4
A ________ topology describes how devices communicate with each other.
What is the correct answer?
4
How would you suspend a telnet session?
What is the correct answer?
4
If you enter a command in either User EXEC mode or Privilege EXEC mode that the IOS does not recognize, the switch or router
B. Tries to resolve the command to an IP address
C. Executes the closest command that it can find in its command set
What is the correct answer?
4
You are given the following addressing information: 192.168.37.192/25. What type of address is this?
What is the correct answer?
4
The dialer map command contains all of the following parameters except __________.
C. Address of local router
D. Speed of the connection
What is the correct answer?
4
What subnet mask would you use to set up a default route?
C. Depends on the type of network number
What is the correct answer?
4
What command assigns a User EXEC password to a 2950 switch?
What is the correct answer?
4
You are given a Class C network with 25 bits of networking. How many subnets do you have?
What is the correct answer?
4
OSPF supports a ________-layer hierarchical design.
What is the correct answer?
4
When connecting a switch to a router, use a ___________ cable.
What is the correct answer?
4
Extended IP ACLs should be placed as close to the ____________ device as possible.
What is the correct answer?
4
_________ negotiates the data link and network layer protocols that will traverse a PPP connection.
What is the correct answer?
4
When configuring a router-on-a-stick, the configuration is done on __________.
What is the correct answer?
4
You have a total of five routers. ________ circuits are required to fully mesh the network, where every router needs ___________ interfaces.
What is the correct answer?
4
When you have configured PPP on an interface and use the show interfaces command, what state indicates the successful negotiation of a network layer protocol?
What is the correct answer?
4
If the port status LED on a 2950 is ________, there is a physical layer connection problem.
A. Flashing green and amber
What is the correct answer?
4
With _________ switching, the switch reads the destination MAC address of the frame and
immediately starts forwarding the frame.
What is the correct answer?
4
EIGRP generates hellos every _________ seconds on LAN segments.
What is the correct answer?
4
_________ allows you to create this summarization: 10.0.0.0/7.
What is the correct answer?
4
To recall a previous command, which of the following would you use?
What is the correct answer?
4
191.75.39.24 is a Class __________ address.
What is the correct answer?
4
On the 1900 switch, how do you enter User EXEC mode?
A. It comes up by default.
B. Enter the letter U in the menu.
C. Enter the letter K in the menu.
D. Enter the letter C in the menu.