Home

What subnet mask would you use to set up a default route?

A. 0.0.0.0

B. 255.255.255.255

C. Depends on the type of network number

D. None of these answers

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. When you have configured PPP on an interface and use the show interfaces command, what state indicates…
  2. The root switch is the one elected with the __________ __________.
  3. __________ allows you to distribute connection requests destined to a single IP address to multiple…
  4. Which frame field is different between ISO HDLC and Cisco's HDLC?
  5. Which router command would you use to test only layer-3 connectivity?
  6. If the 2950's RPS is ________, the external power supply is supplying power.
  7. With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
  8. OSPF hellos are sent every __________ seconds on a multi-access medium.
  9. Extended IP ACLs should be placed as close to the ____________ device as possible.
  10. _________ defines how the Frame Relay DTE and DCE interact with each other.
  11. Which router-on-a-stick command defines the VLAN for the interface?
  12. Which of the following is a valid subnet mask value?
  13. EIGRP will route for ___________.
  14. Which of the following are classless protocols?
  15. RIP has a hold-down period of ____________ seconds.
  16. The _______ program goes out and finds the IOS and loads it.
  17. When using debug with PAP, which of the following message types might you see?
  18. The ___________ is the point where the carrier's responsibility ends and yours begins.
  19. Which prompt indicates that you are at User EXEC mode?
  20. Which router command would you use to view the configuration register value?
  21. Which controller command specifies how ones and zeros are represented on a digital circuit?
  22. What router command saves the active configuration to NVRAM?
  23. You have ISL trunks in your network and five VLANs configured. How many instances of STP are running?
  24. With _________ switching, the switch reads the destination MAC address of the frame andimmediately starts…
  25. Which command is used to define the local addresses that are statically translated to global addresses?
  26. _________ is/are a routed protocol.
  27. A _________ is used to connect networking devices that are in a very close geographic area, such as…
  28. If you wanted a list of parameters for the show command, you would type ________.
  29. The ___________ converts an ISDN four-wire connection to a two-wire connection.
  30. The router automatically saves its configuration.