Home

When a body is subjected to a direct tensile stress (σx) in one plane accompanied by a simple shear stress (τxy), the maximum normal stress i

A. (σx/2) + (1/2) × √(σx² + 4 τ²xy)

B. (σx/2) - (1/2) × √(σx² + 4 τ²xy)

C. (σx/2) + (1/2) × √(σx² - 4 τ²xy)

D. (1/2) × √(σx² + 4 τ²xy)

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The ultimate analysis of coal consists of the determination of the percentage of
  2. According to Kelvin-Planck's statement, a perpetual motion of the __________ is impossible.
  3. The process is adiabatic, if the value of n in the equation pvn = C, is
  4. The entropy may be expressed as a function of
  5. The pressure exerted by an ideal gas is ________ of the kinetic energy of all the molecules contained…
  6. In the below figure, curve D represents_________.
  7. When coal is strongly heated continuously for 42 to 48 hours in the absence of air in a closed vessel,…
  8. For a perfect gas, according to Boyle's law (where p = Absolute pressure, v = Volume, and T = Absolute…
  9. The processes occuring in open system which permit the transfer of mass to and from the system, are…
  10. Which of the following gas has the highest calorific value?
  11. The standard value of atmospheric pressure taken at sea level is
  12. When a body is subjected to two equal and opposite pushes, as a result of which the body tends to reduce…
  13. The point of contra flexure is a point where
  14. The compression ratio for Diesel engines is
  15. In a tensile test on mild steel specimen, the breaking stress as compared to ultimate tensile stress…
  16. For the same maximum pressure and temperature,
  17. Strain energy is the
  18. In S. I. units, the value of the universal gas constant is
  19. In a free expansion process,
  20. According to kinetic theory of gases, the velocity of molecules __________ with the increase in temperature.
  21. A column is said to be a short column, when
  22. Carbonisation of coal consists of
  23. When a beam is subjected to a bending moment, the strain in a layer is __________ the distance from…
  24. Which of the following materials is most elastic?
  25. In the below figure, the stress corresponding to point D is
  26. The tensile strength of the welded joint for double fillet is (where s = Leg or size of the weld, l…
  27. Reversed Joule cycle is known as
  28. The thickness of a thin cylindrical shell with hemispherical ends is __________ that of spherical ends.
  29. A fletched beam is used to
  30. The amount of heat required to raise the temperature of __________ water through one degree is called…