When configuring your terminal emulation software for a console connection, set the flow control to __________.
Hardware
Software
None
Correct Answer :
C. None
Related Questions
With _________ switching, the switch reads the destination MAC address of the frame and
immediately starts forwarding the frame.
Store-and-forward
Cut-through
Fragment-free
Runtless
172.16.240.256 is a class __________ address.
A
B
C
None of the above
VLSM allows a network segment to have more than one subnet mask.
True
False
An _____________ is a public IP address associated with an inside device.
Inside global IP address
Inside local IP address
Outside global IP address
Outside local IP address
___________ has both physical and logical ring topologies.
Ethernet
FDDI
Token Ring
You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol is down. What does this indicate?
There is a physical layer problem.
There is a data link layer problem.
There is a network layer problem.
There is no problem.
You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
00011011.10100010.00000100
00000000.00000001.00000100
00000001.10100010.00000100
00000001.10100001.00000010
What command creates a DHCP address pool on a router?
ip dhcp
ip pool dhcp
ip dhcp pool network
ip dhcp pool
RIP supports load balancing for up to __________ ___________ paths.
Six, unequal-cost
Four, unequal-cost
Four, equal-cost
Six, equal-cost
The function of the MODE button is to __________.
Change the status of the ports
Affect what the SYSTEM and RPS LEDs represent
Affect what the port LEDs represent
Change the status of all the LEDs
Which frame field is different between ISO HDLC and Cisco's HDLC?
Address
Control
Flag
Proprietary
Which of the following is a Network layer protocol for the TCP/IP protocol stack?
TCP
UDP
ICMP
None of these
Which of the following is false concerning VLANs?
A VLAN is a broadcast domain.
A VLAN is a logical group of users.
A VLAN is location-dependent.
A VLAN is a subnet.
Which command assigns a default gateway to the 2950 switch?
(config)# default-gateway
(config-if)# default-gateway
(config-if)# ip default-gateway
(config)# ip default-gateway
Which controller command specifies how ones and zeros are represented on a digital circuit?
framing
linecode
clock source
interface
Which type of traffic is not flooded?
Multicast
Known unicast
Broadcast
Unknown unicast
Which of the following is true concerning ISL?
It is supported on both the 1900 and 2950 switches.
It adds a 26-byte trailer and 4-byte header.
Tagging is done in software.
The original Ethernet frame is not modified.
Which of the following is false concerning CHAP?
It sends an encrypted password.
It sends a challenge.
It is more secure than PAP.
It uses a three-way handshake.
Which of the following is not an advantage of route summarization?
It requires less memory and processing.
It supports smaller routing update sizes.
It contains network problems.
It supports discontiguous subnets.
VLSM allows you to summarize __________ back to the class boundary.
Subnets
Networks
Which router command creates a standard named ACL called test?
ip access-list test
access-list test
ip access-list standard test
access-list standard test
IGRP generates an update every ___________ seconds.
30
60
90
120
The address of a Frame Relay VC is called a ___________.
Data link layer connection identifier
Data layer connection index
Data link connection index
Data link connection identifier
You are given this address space: 172.16.5.0/25. You need one network with 64 hosts and two with 30 hosts. What are the most specific subnet mask values to use?
/25 and /26
/26 and /27
/27 and /28
None of these
When using debug with PAP, which of the following message types might you see?
AUTH-ACK
SUCCESS
CHALLENGE
None of these
You are given a Class C network with 25 bits of networking. How many subnets do you have?
1
2
3
4
A ___________ is basically all of the components, hardware and software, involved
in connecting computers across small and large distances.
LAN
WAN
Network
SAN
Which router-on-a-stick command defines the VLAN for the interface?
vlan
encapsulation
trunk
frame-type
Which IGRP command allows unequal-cost load balancing?
variance
load
balance
network
Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing protocol will your router use for this route?
RIP
OSPF