Home

When connecting a switch to a router, use a ___________ cable.

A. Crossover

B. Straight-through

C. Rollover

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The _______ program goes out and finds the IOS and loads it.
  2. The OSPF process ID is __________.
  3. OSPF supports a ________-layer hierarchical design.
  4. If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
  5. What router command saves the active configuration to NVRAM?
  6. Which of the following is a disadvantage of SANs?
  7. Which router command would you use to test only layer-3 connectivity?
  8. VLSM allows you to summarize 192.168.2.0/24 and 192.168.3.0/24 as 192.168.2.0/25.
  9. RIP generates routing updates every _________ seconds.
  10. If you wanted a list of parameters for the show command, you would type ________.
  11. BPDU stands for ____________.
  12. __________ allows you to distribute connection requests destined to a single IP address to multiple…
  13. Which IGRP command allows unequal-cost load balancing?
  14. With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
  15. A ___________ is similar to a telephone circuit-switched connection.
  16. You have this binary value: 11000001. This equates to _____ in decimal.
  17. A 1924 has _________ Ethernet interfaces.
  18. Which of the following is true concerning 802.1Q?
  19. Extended traceroute works from which mode?
  20. The TCP/IP protocol stack has ________ layers.
  21. You are given a Class C network, 192.168.1.0/24. You need one network with 120 hostsand two networks…
  22. A __________ route is the best path to reach a destination within the topology table.
  23. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  24. _________ has a physical star topology but a logical ring topology.
  25. Which of the following is a private address?
  26. Which protocol supports VLSM?
  27. _________ describe(s) users that can connect to a network from any location.
  28. What would you enter to see the last few commands you entered?
  29. Which of the following is a valid subnet mask value?
  30. Which of the following is stored in ROM? (Choose all correct answers.)