When creating a Cutting Plane line with Auto-CAD it is customary to use a ________ to create the line.
Center line
Polyline
Dashed line
Hatch line
Also checkout these categories
Circulatory System MCQ Atomic Physics Theory MCQ Phylum - Protozoa MCQ Chain Rule MCQ Heat & Mass Transfer MCQ Coding Decoding MCQ Alchohols MCQ Sentence Correction MCQ Anatomy of flowering plant MCQ Phylum - Aschelminthes MCQ Statutory Deductions MCQ Workshop Technology MCQ
- Architectural drawings used to construct a house are often plotted with a scale of ¼ = 1'-0.…
- This is the smallest diameter of a screw thread:
- In oblique projection, important shapes should be in this position relative to the viewing plane:
- This type of rapid prototyping system uses a laser to fuse powdered metals, plastics, or ceramics:
- The Auto-CAD command used to combine two or more primitive shapes into a single complex 3-dimensional…
- This is a line terminated by arrowheads, indicating the direction and extent of a dimension:
- Newer versions of Auto-CAD utilize the ________ to make block library management very easy.
- This type of drawing shows two lines representing the pipe diameter:
- One way to evenly space dimensions on a drawing is to use the ________.
- Geometric primitives include shapes such as ________.
- When lettering a CAD drawing, for clarity you should limit the number of fonts to:
- Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point…
- A secondary auxiliary view is a projection off of the ________.
- On a floor plan the dashed line that appears approximately 24 outside the exterior wall represents the…
- This is the measured size of a finished part:
- A full scale technical drawing will have a scale factor of ________.
- Lines of an isometric drawing that are not parallel to the isometric axes are called this:
- This is the term for the range of tightness or looseness resulting from the allowances and tolerances…
- This is how axonometric, oblique, and perspective sketches show objects:
- This type of solid has a polygon for a base and triangular lateral faces that intersect at a vertex:
- These types of projectors converge at a vanishing point:
- Most architectural firms and mechanical design companies utilize different categories of blocks. These…
- Placement of dimensions on a drawing is controlled by ________.
- This is the intersection of the ground plane with the picture plane:
- Isometric drawings are often used by ________ to help illustrate complex designs.
- The primary unit of measurement for engineering drawings and design in the mechanical industries is…
- The Offset tool should only be used for placing ________ in an isometric drawing.
- Once the architect has finalized the house plans with the client any changes to the design requested…
- The text used on a typical detail sheet should be ________.
- These units are based on inch-foot and yard measurements: