Home

When creating your own blocks it is important to avoid drawing any portion of the block in the ________ layer.

A. Zero

B. Center line

C. Hatch

D. Hidden line

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. This type of projection is when projectors are parallel to each other, but is at an angle other than…
  2. Drafters should use a ________ in a section view of a mechanical part that includes the cylindrical…
  3. In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in…
  4. In order to set drawing limits for a C size architectural drawing the drafter should set the limits…
  5. A full scale technical drawing will have a scale factor of ________.
  6. When creating your own blocks it is important to avoid drawing any portion of the block in the ________…
  7. The organized and orderly approach to solving problems is known as the:
  8. In perspective drawings this is placed between the observer and the object:
  9. An accurate record of changes made to release drawings is tracked via this:
  10. When positioning this feature of perspective projection, the centerline of the cone of visual rays should…
  11. Drawings created with commercial software are typically saved as:
  12. Acceptable parts must not extend beyond this:
  13. Geometric primitives include shapes such as ________.
  14. In order to create an isometric circle to represent a hole through the top surface of a box, the drafter…
  15. Oblique drawings are dimensioned in a similar fashion as these types of drawings:
  16. The Conceptual Visual Style tool is located on the ________ toolbar.
  17. A back or backing weld is a type of:
  18. These drawings are given to contractors to perform work or manufacture individual parts:
  19. The thread note for a typical bolt will include the ________.
  20. On typical electronic diagrams, these items need not be shown unless they are needed for clarification:
  21. This type of circuit is a semiconductor wafer or chip:
  22. Some traditional board drafters preferred the drafting machine over the parallel straight edge because…
  23. These maps are used in planning installations of trees, shrubbery, drives, and other garden features:
  24. A civil engineer working on a bridge design would probably rely on his ________ scale for checking printed…
  25. In offset sections, offsets or bends in the cutting plane are all:
  26. In this type of view, the cutting plane line indicates both the location of the cutting plane and the…
  27. Which of the following is one of the basic types of welded joints:
  28. A fillet is a rounded surface on the ________ corner of a part.
  29. Perspective drawings are classified according to their number of these features:
  30. A line drawn with a long section, short dash, and another long section is a ________.