Home

When drawing a line using the relative coordinate system a line is created from ________.

A. 0, 0

B. The ending point of the last line

C. The beginning point of the last line

D. None of the above

Related Questions

  1. The dimension text size is determined by what the architect deems necessary in __________.
  2. When the receding lines are true length, and the projectors are at 45 degrees to the plane of projection,…
  3. This is an angled surface used on cylinders to make them easier to handle:
  4. In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in…
  5. This allows the designer to conceptualize objects more easily without having to make costly illustrations,…
  6. In these drawings it is necessary to show cut surfaces and distinguish between adjacent parts:
  7. The Free Orbit tool is found on the ________ toolbar.
  8. The typical parts list should include the ________.
  9. An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
  10. In this type of dimensioning, allowance must be made for bends:
  11. The condition of a part when it contains the least amount of material is referred to as ________.
  12. The offset distance for the width (front to back) distance of the auxiliary view is the same distance…
  13. A cylinder can be created by drawing a rectangular shape then the ________ tool.
  14. This is a conical-shaped recess around a hole, often used to receive a tapered screw head:
  15. This type of surface is tipped to all principal planes of projection and does not appear true size in…
  16. Before starting an isometric drawing in Auto-CAD the drafter needs to ________.
  17. The first step in creating a traditional technical drawing is to ________.
  18. Angles project true size only when the plane containing the angle and plane of projection are this:
  19. In order to set drawing limits for a C size architectural drawing the drafter should set the limits…
  20. Once a drawing is determined to be complete, the title block is used to document the change from:
  21. 5.These items typically are not used in new designs, but are still common in high-power amplifiers:
  22. Students can complete an associate's degree in drafting which normally takes about ________ years to…
  23. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
  24. This is a line terminated by arrowheads, indicating the direction and extent of a dimension:
  25. In this type of section, one quarter of the object is removed:
  26. Some common blocks used by architectural drafters include ________.
  27. The architectural and construction industries use the United States National CAD standard (NCS) system…
  28. An advantage of this type of view is that each view shows the object all the way through as if it were…
  29. Architectural dimensioning standards allow for the placement of dimensions inside the floor plan. These…
  30. In order to create an accurate assembly drawing the drafter should create the ________ drawings first.

Please do not use chat terms. Example: avoid using "grt" instead of "great".