Home

When the crank is at the outer dead centre, in a reciprocating steam engine, then the acceleration of the piston will be

A. ω² r {(n + 1)/n}

B. ω² r {(n - 1)/n}

C. ω² r {n/(n + 1)}

D. ω² r {n/(n - 1)}

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. A governor is said to be stable, if the
  2. In the below figure, PC is the connecting rod and OC is the crank making an angle θ with the line…
  3. The frequency of oscillation of a compound pendulum is
  4. When a mass of a critically damped single degree of freedom system is deflected from its equilibrium…
  5. A thin circular disc is rolling with a uniform linear speed, along a straight path on a plane surface.…
  6. In a reciprocating steam engine, when the crank has turned from inner dead centre through an angle θ,…
  7. The frictional torque transmitted in a flat collar bearing, considering uniform pressure, is (where…
  8. The instantaneous centre of a rigid thin disc rolling on a plane rigid surface is located at
  9. When the two elements of a pair have __________ when in motion, it is said to a lower pair.
  10. Consider the following mechanisms:1. Oscillating cylinder engine mechanism2. Toggle mechanism3. Radial…
  11. A mass of 1 kg is attached to the end of a spring with a stiffness of 0.7 N/mm. The critical damping…
  12. In a four bar chain or quadric cycle chain
  13. The main disadvantage of the sliding pair is that it is
  14. Which one of the following is an exact straight line mechanism using lower pairs?
  15. Higher pairs are those which have
  16. A mechanism consisting of four links is called a __________ mechanism.
  17. According to Kennedy's theorem, if three bodies have plane motions, their instantaneous centers lie…
  18. The frictional torque transmitted in a flat pivot bearing, considering uniform wear, is (where μ…
  19. When two pulleys of different diameters are connected by means of an open belt, the angle of contact…
  20. Two pulleys of radii r₁ and r₂ and at distance x apart are connected by means of an open…
  21. In a screw jack, the effort required to lower the load W is given by
  22. The effort of a Porter governor is equal to (where c = Percentage increase in speed, m = Mass of ball,…
  23. To transmit power from one rotating shaft to another whose axes are neither parallel nor intersecting,…
  24. The stress induced in a body will be shear stress, when it is subjected to
  25. The steering of a ship means
  26. Oldhams coupling is an inversion of the kinematic chain used in
  27. Peaucelliers mechanism has
  28. The example of completely constrained motion is a
  29. A motor car moving at a certain speed takes a left turn in a curved path. If the engine rotates in the…
  30. In a vibrating system, if the actual damping coefficient is 40 N/m/s and critical damping coefficient…