Home

When the shaft rotates in anticlockwise direction at slow speed in a bearing, it will

A. Have contact at the bottom most of the bearing

B. Move towards right of the bearing making no metal to metal contact

C. Move towards right of the bearing making the metal to metal contact

D. Move towards left of the bearing making metal to metal contact

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. For a square key made of mild steel, the shear and crushing strength are related as
  2. Transverse fillet welded joints are designed for
  3. The ratio of pitch circle diameter in millimetres to the number of teeth, is called
  4. A steel containing upto 0.15% carbon is known as
  5. The constant factor in case of R10 series of preferred numbers is
  6. The ratio of endurance limit in shear to the endurance limit in flexure is
  7. The rated life of a bearing varies
  8. Two helical springs of the same material and of equal circular crosssection, length and number of turns,…
  9. The stiffness of a closely coiled helical spring subjected to an axial load W is equal to (where G =…
  10. In radial cams, the follower moves
  11. According to I.B.R., when the thickness of boiler shell (t) is greater than 8 mm, then the diameter…
  12. For general industrial machinery, the ratio of the length of journal to its diameter is taken as
  13. The application of third type levers is found in
  14. When the shaft rotates in anticlockwise direction at slow speed in a bearing, it will
  15. Oldham coupling is used to connect two shafts
  16. The value of Lewis form factor used in design of gears is
  17. In V-belt drive, belt touches
  18. The size of a gear is usually specified by
  19. The maximum shear stress theory is used for
  20. Which is correct statement? Stress concentration in static loading is
  21. When the bolt is very yielding as compared to the connected members, then the resultant load on the…
  22. In helical gears, the right hand helixes on one gear will mesh __________ helixes on the other gear.
  23. In cylindrical cams, the follower moves
  24. In a flange coupling, the flanges are coupled together by means of
  25. A screw is said to be over hauling screw, if its efficiency is
  26. The static tooth load should be __________ the dynamic load.
  27. In helical gears, the distance between similar faces of adjacent teeth along a helix on the pitch cylinders…
  28. Allen bolts are
  29. A localised compressive stress at the area of contact between two members is known as
  30. Surface endurance limit of gear material is dependent upon its