Home

When the wet steam is throttled but still remains wet at the exit of the throttle valve, then its temperature & dryness fraction respectively

A. Decreases & increases

B. Increases & increases

C. Increases & decreases

D. Decreases & decreases

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The joint for soldering is supported by binding wire made of
  2. Dryness fraction of dry steam is
  3. The refrigerant freon-12 is chemically
  4. __________ is the most important element, which controls the physical properties of steel.
  5. Fire in fuel gas pipelines is extinguished most effectively by
  6. Corrosion of metals cannot be prevented by its
  7. Thermistors are used in __________ devices.
  8. Cold heading or upsetting is categorised as the __________ process.
  9. __________ are normally subjected to sub-zero treatment.
  10. Pressure exerted by a liquid depends upon its
  11. Dew point temperature always gives an indication of the __________ of the moist air.
  12. The lightest non-inflammable gas is
  13. Milk is fat dispersed in water. It is an example of
  14. A thin, flat & square plate measuring 2 m × 2 m is freely hanging in ambient air at 25°C.…
  15. The thickness of oxide film is y at time t. If are the temperature dependent constants, the parabolic…
  16. The condition of diffraction from a crystal is given by
  17. Notched bar test is used for testing the __________ of a material.
  18. A common disinfectant used in village wells for disinfection of water is
  19. Which of the following has the highest modulus of elasticity (about 7 × 106 kg/cm2)?
  20. Pick out the wrong statement.
  21. Which of the following metals is the most prone to work hardening?
  22. Which of the following has the least value of ultimate tensile strength (UTS)?
  23. Hot working of lead is carried out at
  24. For preparation of porous bearings by powder metallurgy, preferred particle shape is
  25. Corrosion rate cannot be lowered by reducing the __________ of the corroding medium.
  26. The 'laughing gas' is
  27. Heat release during phase change is observed in case of a/an
  28. Cold chisels hammers are made of
  29. Unit of viscosity in CGS system is
  30. Damage to metal surface by mechanical action is called