Which 2950 command enables trunking?
switchport mode trunk
trunking on
trunking enable
switchport trunk on
Correct Answer :
A. switchport mode trunk
Related Questions
_________ allows you to create this summarization: 10.0.0.0/7.
Subnetting
CDR
Supernetting
VLSM
You are given a class C network, 192.168.1.0/24. You need one network with 120 hosts and three networks with 60 hosts. What subnet mask values would you use?
255.255.255.128 and 255.255.255.192
255.255.255.128
255.255.255.192
None of these
Which command is used to define the local addresses that are statically translated to global addresses?
ip nat inside source static
ip nat inside
ip nat inside source list
ip nat pool
Which 2950 command assigns a VLAN to an interface?
vlan-membership static
vlan
switchport access vlan
switchport mode access
An _____________ is a public IP address associated with an inside device.
Inside global IP address
Inside local IP address
Outside global IP address
Outside local IP address
When examining the IP routing table, an EIGRP route will be shown as what letter?
I
E
O
D
Which command assigns a default gateway to the 2950 switch?
(config)# default-gateway
(config-if)# default-gateway
(config-if)# ip default-gateway
(config)# ip default-gateway
Which router command would take you back to a suspended telnet session?
reconnect
connect
resume
toggle
A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.
WAN
LAN
MAN
LAN and MAN
Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing protocol will your router use for this route?
RIP
OSPF
172.16.240.256 is a class __________ address.
A
B
C
None of the above
Which control sequence moves the cursor to the end of the line?
CTRL-A
ctrl-p
ctrl-e
ctrl-z
When connecting a router to a PC, use a __________ cable.
Crossover
Straight-through
Rollover
When you have configured PPP on an interface and use the show interfaces command, what state indicates the successful negotiation of a network layer protocol?
ACK
CHALLENGE
CLOSED
OPEN
You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
00011011.10100010.00000100
00000000.00000001.00000100
00000001.10100010.00000100
00000001.10100001.00000010
When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
pat
overload
load
port
You are given the following addressing information: 192.168.37.192/25. What type of address is this?
Network
Directed Broadcast
Host
With _________ switching, the switch reads the destination MAC address of the frame and
immediately starts forwarding the frame.
Store-and-forward
Cut-through
Fragment-free
Runtless
Which of the following are classless protocols?
IGRP
EIGRP
IGRP and EIGRP
Neither IGRP or EIGRP
Which command defines interesting traffic?
dialer-group
dialer-list
dialer map
dialer remote-name
During the learning function, the switch places addresses and ports in a(n) _________ table.
IP address
learning
CAM
memory
With a crossover cable, which pins are crossed over?
1 and 2, 3 and 6
1 and 3, 2 and 6
1 and 4, 2 and 6
1 and 3, 4 and 6
You are given the following addressing information: 172.17.16.255/23. What type of address is this?
Network
Directed Broadcast
Host
Choose the following that a standard IP ACL can match on.
Destination address
IP protocol
IP protocol information
None of the above
VLSM allows you to summarize __________ back to the class boundary.
Subnets
Networks
EIGRP uses the _________ algorithm to update its routing table.
Bellman-Ford
Dijkstra
DUAL
Integrated
Which of the following is a private address?
192.169.7.17
172.32.28.39
10.1.256.8
172.16.255.89
You have a total of five routers. ________ circuits are required to fully mesh the network, where every router needs ___________ interfaces.
5, 5
8, 4
10, 5
10, 4
Which of the following is false concerning VLANs?
A VLAN is a broadcast domain.
A VLAN is a logical group of users.
A VLAN is location-dependent.
A VLAN is a subnet.
Which is true concerning a port in a listening state? (Choose all correct answers.)
.
It remains there for 15 seconds.
It forwards BPDUs and builds the CAM table
It remains there for 20 seconds.
It forwards BPDUs.