Home

Which command activates an IP ACL on a router's interface?

A. access-list

B. ip access-group

C. access-class

D. access-group

Related Questions

  1. _________ describe(s) users working from home.
  2. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  3. What would you use to prevent a packet from traveling around a routing loop forever?
  4. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  5. The root switch is the one elected with the __________ __________.
  6. EIGRP generates hellos every _________ seconds on LAN segments.
  7. Which frame field is different between ISO HDLC and Cisco's HDLC?
  8. You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
  9. The ___________ is the point where the carrier's responsibility ends and yours begins.
  10. What must you do to enable IP routing on your router? (Choose all of the correct answers.)
  11. __________ allows you to distribute connection requests destined to a single IP address to multiple…
  12. If the 1900 SYSTEM LED is _________, a system POST test has failed.
  13. When using debug with PAP, which of the following message types might you see?
  14. You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there…
  15. You are in Interface Subconfiguration mode and want to completely return to Privilege EXEC mode. What…
  16. There are _________ actions a router can take when there is a match on an ACL statement
  17. Which of the following WAN categories does ISDN fall under?
  18. What subnet mask would you use to set up a default route?
  19. The switch port that is chosen to forward traffic for a segment is called a __________.
  20. A __________ route is the best path to reach a destination within the topology table.
  21. A _________ connects two or more LANs in the same geographic area.
  22. With a crossover cable, which pins are crossed over?
  23. PPP can do all of the following except ___________.
  24. Which of the following is false concerning CHAP?
  25. Which 2950 command assigns a VLAN to an interface?
  26. Which router-on-a-stick command defines the VLAN for the interface?
  27. When choosing a dynamic routing protocol, which of the following should not be considered?
  28. RIP has a hold-down period of ____________ seconds.
  29. Which prompt indicates that you are at User EXEC mode?
  30. _________ is/are a routed protocol.

Please do not use chat terms. Example: avoid using "grt" instead of "great".