Home

Which command is used to define the local addresses that are statically translated to global addresses?

A. ip nat inside source static

B. ip nat inside

C. ip nat inside source list

D. ip nat pool

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. What uses 64 Kbps of bandwidth?
  2. What would you use to prevent a packet from traveling around a routing loop forever?
  3. The address of a Frame Relay VC is called a ___________.
  4. You are given a Class B network with a subnet mask of 255.255.255.192. How many hostaddresses are there…
  5. What would you enter to see the last few commands you entered?
  6. Which prompt indicates that you are at User EXEC mode?
  7. Which of the following is a valid subnet mask value?
  8. Which router command specifies the ISDN switch the router is connected to?
  9. The TCP/IP protocol stack has ________ layers.
  10. A VTP server switch generates a summary advertisement every _________ minutes.
  11. A _________ routes between different autonomous systems.
  12. VLSM allows you to summarize __________ back to the class boundary.
  13. You have this binary value: 11000001. This equates to _____ in decimal.
  14. What router command saves the active configuration to NVRAM?
  15. You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
  16. Which is an example of a hybrid protocol?
  17. A __________ topology uses a single connection to connect all devices together.
  18. 172.16.240.256 is a class __________ address.
  19. Which of the following commands belongs on the physical interface when using dialer profiles?
  20. Which command activates an IP ACL on a router's interface?
  21. A routing protocol that supports route summarization must perform all except which of the following?
  22. Ethernet ___________ has/have both a physical and logical bus topology.
  23. What must you do to enable IP routing on your router? (Choose all of the correct answers.)
  24. Which command assigns a default gateway to the 2950 switch?
  25. What command activates the IP routing process?
  26. Which of the following is true concerning RIPv2?
  27. You are given the following addressing information: 172.17.16.255/23. What type of address is this?
  28. _________ allows you to create this summarization: 10.0.0.0/7.
  29. If you wanted a list of parameters for the show command, you would type ________.
  30. Which of the following is true concerning ISL?