Home

Which frame field is different between ISO HDLC and Cisco's HDLC?

A. Address

B. Control

C. Flag

D. Proprietary

Related Questions

  1. The root switch is the one elected with the __________ __________.
  2. OSPF hellos are sent every __________ seconds on a multi-access medium.
  3. A routing protocol that supports route summarization must perform all except which of the following?
  4. Which router command performs an overwrite process? (Choose all correct answers.)
  5. You are given the following addressing information: 10.0.8.0/22. What type of address is this?
  6. You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
  7. With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
  8. VLSM allows you to summarize __________ back to the class boundary.
  9. Which prompt indicates that you are at User EXEC mode?
  10. Which router-on-a-stick command defines the VLAN for the interface?
  11. You are given the following addressing information: 172.17.16.255/23. What type of address is this?
  12. An OSPF's router ID is based on __________.
  13. Which of the following is not true concerning TCP?
  14. The _______ program goes out and finds the IOS and loads it.
  15. When a carrier experiences congestion, it marks the _______ bit in the header of the Frame Relay frame.
  16. You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there…
  17. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  18. When you have configured PPP on an interface and use the show interfaces command, what state indicates…
  19. With a crossover cable, which pins are crossed over?
  20. If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
  21. Which VTP mode(s) will propagate VTP messages?
  22. Which router command creates a standard named ACL called test?
  23. Which is true concerning a port in a listening state? (Choose all correct answers.).
  24. You have this binary value: 11000001. This equates to _____ in decimal.
  25. Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing…
  26. Which 2950 command enables trunking?
  27. Extended IP ACLs should be placed as close to the ____________ device as possible.
  28. Which of the following is the most expensive type of WAN connection?
  29. Which of the following reasons might you need to use address translation?
  30. The ___________ is the point where the carrier's responsibility ends and yours begins.

Please do not use chat terms. Example: avoid using "grt" instead of "great".