Which is an example of a hybrid protocol?



C. RIPv1


Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. You execute the line console 0 command from Configuration mode. What will the router's prompt be?
  2. You are given a Class C network with 25 bits of networking. How many subnets do you have?
  3. Which protocol supports VLSM?
  4. What uses 64 Kbps of bandwidth?
  5. A routing protocol will use a _________ to determine which path is the best path.
  6. ________ topologies in NBMA environments do not have problems with split horizon.
  7. ___________ defines LAPD, which is responsible for the data-link layer connection between the router…
  8. Which router command would you use to view the configuration register value?
  9. Which of the following is true concerning ISL?
  10. How many steps do LCP and NCP go through when setting up a connection?
  11. VLSM allows a network segment to have more than one subnet mask.
  12. What must you do to enable IP routing on your router? (Choose all of the correct answers.)
  13. Which router command specifies the ISDN switch the router is connected to?
  14. Which of the following are not features of ACLs?
  15. You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol…
  16. Enter the wildcard mask value to match on every bit position in an address: _________.
  17. IOS images can be loaded from all the following except:
  18. VLSM allows you to summarize and as
  19. The address of a Frame Relay VC is called a ___________.
  20. Which of the following is stored in ROM? (Choose all correct answers.)
  21. With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
  22. You are given the following addressing information: What type of address is this?
  23. When choosing a dynamic routing protocol, which of the following should not be considered?
  24. The ___________ converts an ISDN four-wire connection to a two-wire connection.
  25. Which of the following is true concerning 802.1Q?
  26. Which interface type is used to connect to the serial interface of a router?
  27. OSPF hellos are sent every __________ seconds on a multi-access medium.
  28. The TCP/IP protocol stack has ________ layers.
  29. A ___________ is basically all of the components, hardware and software, involvedin connecting computers…
  30. Choose the following that a standard IP ACL can match on.