Home

Which of the following combination of length and cross-sectional area will give a certain volume of copper the least resistance?

A. 2L and1/2 A

B. Does not matter because the volume of copper remains the same

C. L and A

D. ½ L and 2 A

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The power factor of a certain circuit in which the voltage lags behind the current is 80 %. To increase…
  2. Which of the following dielectric materials makes the lowest-capacitance capacitor?
  3. Conventional flow assumes charges flow from
  4. An alloy composed of 84 % coppera 12 % manganese and 4 % nickel.
  5. Which of the following is not considered a physical factor affecting resistance?
  6. In a parallel bank with unequal branch resistances
  7. The ratio between the reactive power and the apparent power of an ac load is called
  8. What is the resonant frequency of a circuit when L of 3 microhenrys and C of 40 picofarads are in series?
  9. For a series circuita the higher the quality factor
  10. When current and voltage arte in phase in an ac circuita the ___ is equal to zero.
  11. What maximum voltage can be applied across the capacitor of time?
  12. A series RLCcircuit consists of a 10 resistor in series with L = 10 Ha and C= 100 F. Determine a new…
  13. In a circuita a passive element is one which
  14. If three 100-pF capacitors are connected in seriesa then the total capacitance is
  15. Liquids that are good conductors because of ionization are called
  16. In dividing or multiplying phasor quantitiesa ___ form is used.
  17. A capacitance of 6 F means
  18. The graph between an alternating quantity and time is called
  19. High resistance values are a consequence of the ___ of the film.
  20. Which is considered as the effect of a dielectric material?
  21. A capacitor requires 12 C of charge to raise its potential of 3 V. What is the capacitance of the capacitor?
  22. A capacitor of 0.5 F charged to 220 V is connected across an uncharged 0.5 F capacitor. What is the…
  23. If a coil has a Q of 10a it means that
  24. In an RL series circuita
  25. The potential gradient in a cable is maximum in
  26. A rheostat is a form of
  27. The ratio between the active power and the apparent power of a load in an ac circuit is called
  28. The farad is not equivalent to which of the following combination of units
  29. Nortons theorem is ____ Thevenins theorem.
  30. Which of the following has a positive temperature coefficient?