Related Questions
What is the correct answer?
4
When using the show interfaces command, which Frame Relay information can you not see?
A. The DLCI number used for LMI
B. The number of LMIs sent and received
What is the correct answer?
4
Which 2950 command assigns a VLAN to an interface?
A. vlan-membership static
C. switchport access vlan
D. switchport mode access
What is the correct answer?
4
The _______ program goes out and finds the IOS and loads it.
What is the correct answer?
4
Enter the wildcard mask value to match on every bit position in an address: _________.
What is the correct answer?
4
A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.
What is the correct answer?
4
If you see a VC with an inactive status, this indicates ____________.
A. The connection between both Frame Relay DTEs is up and operational.
B. The connection between your Frame Relay DTE and DCE is up and operational, but there is something wrong with connection between your connected Frame Relay switch and the destination DTE.
C. You are not receiving any LMI messages from the Frame Relay switch.
What is the correct answer?
4
You have a total of five routers. ________ circuits are required to fully mesh the network, where every router needs ___________ interfaces.
What is the correct answer?
4
VLSM allows a network segment to have more than one subnet mask.
What is the correct answer?
4
The address of a Frame Relay VC is called a ___________.
A. Data link layer connection identifier
B. Data layer connection index
C. Data link connection index
D. Data link connection identifier
What is the correct answer?
4
_________ allows you to create this summarization: 10.0.0.0/7.
What is the correct answer?
4
Which type of traffic is sent to a group of devices?
What is the correct answer?
4
The root switch is the one elected with the __________ __________.
What is the correct answer?
4
Which router-on-a-stick command defines the VLAN for the interface?
What is the correct answer?
4
You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there on each subnet?
What is the correct answer?
4
If the 1900 SYSTEM LED is _________, a system POST test has failed.
D. Flashing green and amber
What is the correct answer?
4
_________ negotiates the data link and network layer protocols that will traverse a PPP connection.
What is the correct answer?
4
Distance vector protocols use ___________ to disseminate routing information.
What is the correct answer?
4
Which of the following situations are best for DDR connections?
A. Primary WAN connection
B. A lot of constant traffic
What is the correct answer?
4
Which metric components, by default, are used in IGRP? (Choose all the correct answers.)
What is the correct answer?
4
How many steps do LCP and NCP go through when setting up a connection?
What is the correct answer?
4
PPP can do all of the following except ___________.
What is the correct answer?
4
A routing protocol that supports route summarization must perform all except which of the following?
A. Carry the subnet mask with the network entry.
B. Make routing decisions based on the entire destination IP address.
C. Summarize entries so that the same lowest-order bits match.
What is the correct answer?
4
Which router command creates a standard named ACL called test?
C. ip access-list standard test
D. access-list standard test
What is the correct answer?
4
Which of the following is false concerning VLANs?
A. A VLAN is a broadcast domain.
B. A VLAN is a logical group of users.
C. A VLAN is location-dependent.
What is the correct answer?
4
EIGRP will route for ___________.
D. IP, IPX, and AppleTalk
What is the correct answer?
4
A __________ route is the best path to reach a destination within the topology table.
What is the correct answer?
4
_________ has a physical star topology but a logical ring topology.
What is the correct answer?
4
You are given the following addressing information: 10.0.8.0/22. What type of address is this?
What is the correct answer?
4
Which of the following is true concerning ISL?
A. It is supported on both the 1900 and 2950 switches.
B. It adds a 26-byte trailer and 4-byte header.
C. Tagging is done in software.
D. The original Ethernet frame is not modified.
What is the correct answer?
4
If the port status LED on a 2950 is ________, there is a physical layer connection problem.
A. Flashing green and amber