Home

Which of the following is false concerning VLANs?

A. A VLAN is a broadcast domain.

B. A VLAN is a logical group of users.

C. A VLAN is location-dependent.

D. A VLAN is a subnet.

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
  2. With _________ switching, the switch reads the destination MAC address of the frame andimmediately starts…
  3. A ___________ is basically all of the components, hardware and software, involvedin connecting computers…
  4. When examining the IP routing table, an EIGRP route will be shown as what letter?
  5. Which VTP mode(s) will propagate VTP messages?
  6. Which controller command specifies how ones and zeros are represented on a digital circuit?
  7. With a crossover cable, which pins are crossed over?
  8. If the 2950's RPS is ________, the external power supply is supplying power.
  9. Which prompt indicates that you are at User EXEC mode?
  10. What would you enter to see the last few commands you entered?
  11. The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a…
  12. Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing…
  13. A _________ connects two or more LANs in the same geographic area.
  14. Which of the following is a private address?
  15. The ___________ is the point where the carrier's responsibility ends and yours begins.
  16. You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol…
  17. __________ allows you to distribute connection requests destined to a single IP address to multiple…
  18. Annex A is which LMI standard?
  19. Which of the following is false concerning OSPF?
  20. What router command saves the active configuration to NVRAM?
  21. An _____________ is a public IP address associated with an inside device.
  22. Which router command would you use to view the configuration register value?
  23. Ethernet ___________ has/have both a physical and logical bus topology.
  24. You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
  25. Which interface type is used to connect to the serial interface of a router?
  26. Which IGRP command allows unequal-cost load balancing?
  27. There are _________ actions a router can take when there is a match on an ACL statement
  28. What command assigns a User EXEC password to a 2950 switch?
  29. Which type of routing protocol uses the Shortest Path First algorithm?
  30. The OSPF process ID is __________.