Home

Which of the following is not an advantage of DHCP?

A. It allows for the use of private addressing.

B. It reduces the amount of configuration on devices.

C. It reduces likelihood of configuration errors.

D. It gives you more control by centralizing IP addressing information.

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. If you enter a command in either User EXEC mode or Privilege EXEC mode that the IOS does not recognize,…
  2. VLSM allows you to summarize __________ back to the class boundary.
  3. EIGRP will route for ___________.
  4. __________ allows you to distribute connection requests destined to a single IP address to multiple…
  5. Which of the following is false concerning VLANs?
  6. Which of the following reasons might you need to use address translation?
  7. What would you enter to see the last few commands you entered?
  8. Which of the following commands belongs on the physical interface when using dialer profiles?
  9. _________ describe(s) users that can connect to a network from any location.
  10. Which command takes you from Privilege EXEC mode to User EXEC mode?
  11. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  12. With a crossover cable, which pins are crossed over?
  13. RIP has a maximum hop count of ____________ hops.
  14. _________ has a physical star topology but a logical ring topology.
  15. You are given a Class B network with a subnet mask of 255.255.255.192. How many hostaddresses are there…
  16. If the 2950's RPS is ________, the external power supply is supplying power.
  17. OSPF uses __________ as a metric.
  18. You are at User EXEC mode and type the letter e. What message appears?
  19. When connecting a switch to a router, use a ___________ cable.
  20. If you see a VC with an inactive status, this indicates ____________.
  21. Which of the following is true concerning ISL?
  22. Which of the following is stored in ROM? (Choose all correct answers.)
  23. Which prompt indicates that you are at User EXEC mode?
  24. Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________…
  25. With _________ switching, the switch reads the destination MAC address of the frame andimmediately starts…
  26. When using the show interfaces command, which Frame Relay information can you not see?
  27. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  28. When choosing a dynamic routing protocol, which of the following should not be considered?
  29. With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
  30. Distance vector protocols use ___________ to disseminate routing information.