Home

Which of the following is preferred for riveting?

A. Lap joint

B. Butt joint

C. Either (A) or (B)

D. Neither (A) nor (B)

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. __________ metal is used as a bearing liner material.
  2. __________ test can be termed as the semidestructive test.
  3. Maximum hardenability of steel depends upon its
  4. Metalloids
  5. Oxyacetylene reducing flame is used while carrying out welding on
  6. The value of for air & most common gases can be safely assumed to be
  7. A reduction in thermal resistance during heat transfer does not occur in the
  8. Increase in the entropy of a system represents the
  9. In a forced draft cooling tower, water is cooled from 95 to 80°F by exposure to air with a wet bulb…
  10. Maximum heat dissipation occurs from a steel wire (k = 0.5 W/m. k) of 15 mm diameter exposed to air…
  11. __________ flux is used for the extraction of metal from its self fluxing ores.
  12. Electrometallurgical methods of metal extraction is normally used for those metals
  13. Which of the following heat treatment processes is usually applied to castings?
  14. Resilience of a bolt can be increased by increasing its
  15. The best guide to judge the general quality of water is the measurement of its
  16. __________ furnace is generally used in the non-ferrous foundries.
  17. Which of the following processes follows the hardening process for reducing the hardening strains &…
  18. Temperature attained in soldering of metals is about __________ °C.
  19. Heating of ferromagnetic materials to a temperature above Curie temperature makes it
  20. __________ is not a case hardening process.
  21. The minimum and the maximum number of members required to form a Private Limited Joint Stock Company…
  22. For an ideal gas, Cp - Cv is
  23. The thermodynamic law, = constant, is not followed by the
  24. Softening of hardened steel is done by its
  25. Name the safety device used to protect the boiler, when the water level falls below a minimum level.
  26. Resistance of an electrical conductor is proportional to its (where, l = length and A = cross-sectional…
  27. Main constituent of bone ash is
  28. Pick out the wrong statement.
  29. In the Bayer's process, bauxite is digested under pressure using
  30. The effect of friction on the flow of steam through a nozzle is to decrease the __________ of steam.