Home

Which of the following is true concerning bridges?

A. They switch frames in hardware.

B. They support half- and full-duplexing.

C. They support one collision domain for the entire bridge.

D. They do only store-and-forward switching.

You can do it
  1. Which of the following is stored in ROM? (Choose all correct answers.)
  2. A 1924 has _________ Ethernet interfaces.
  3. RIP has a maximum hop count of ____________ hops.
  4. _________ allows you to create this summarization: 10.0.0.0/7.
  5. A Class A address has _________ host bits.
  6. Which would you use to move your cursor back one word?
  7. The ___________ converts an ISDN four-wire connection to a two-wire connection.
  8. If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
  9. Which metric components, by default, are used in IGRP? (Choose all the correct answers.)
  10. The address of a Frame Relay VC is called a ___________.
  11. IOS images can be loaded from all the following except:
  12. With a crossover cable, which pins are crossed over?
  13. A ___________ in a bit position of a wildcard mask means that the same bit position in the condition…
  14. ___________ only translates one (and only one) IP address to another.
  15. You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there…
  16. A _________ is a network that provides a secure connection from a company to other business partners.
  17. When choosing a WAN solution, consider all of the following except __________.
  18. You are given a class C network, 192.168.1.0/24. You need one network with 120 hosts and three networks…
  19. If the port status LED on a 2950 is ________, there is a physical layer connection problem.
  20. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  21. The dialer map command contains all of the following parameters except __________.
  22. ___________ has both physical and logical ring topologies.
  23. 172.16.240.256 is a class __________ address.
  24. Which router command creates a standard named ACL called test?
  25. A __________ route is the best path to reach a destination within the topology table.
  26. The slot number of a 1900's Fast Ethernet uplink ports is ________.
  27. Which router command would you use to view the configuration register value?
  28. When connecting a router to a PC, use a __________ cable.
  29. ___________ defines LAPD, which is responsible for the data-link layer connection between the router…
  30. You are given the following addressing information: 192.168.37.192/25. What type of address is this?