Home

Which of the following is used to control the speed variations of the engine caused by the fluctuations of the engine turning moment?

A. D-slide valve

B. Governor

C. Flywheel

D. Meyer's expansion valve

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. A point on a connecting link (excluding end points) of a double slider crank mechanism traces a
  2. The sense of Coriolis component is such that it
  3. When two links are connected by a pin joint, their instantaneous centre lies
  4. The maximum velocity of a particle moving with simple harmonic motion is
  5. In a simple train of wheels, the velocity ratio __________ the intermediate wheels.
  6. The brake commonly used in railway trains is
  7. In the two rotor system as shown in the below figure (I₁ < I₂), a node of vibration is…
  8. When the load on the engine increases, it becomes necessary to increase the supply of working fluid…
  9. Instantaneous center of rotation of a link in a four bar mechanism lies on
  10. In order to give a complete secondary balance of a multi-cylinder inline engine,
  11. In a circular arc cam with roller follower, the acceleration in any position of the lift will depend…
  12. The efficiency of a screw jack is maximum, when (where α = Helix angle, and φ = Angle of friction)
  13. In gears, interference takes place when
  14. The frequency of oscillation at compared to earth will be
  15. The frictional torque transmitted in a flat collar bearing, considering uniform pressure, is (where…
  16. Which of the following statement is correct?
  17. The factional torque for square thread at the mean radius r while raising load W is given by
  18. When a ship travels in a sea, which of the effect is more dangerous
  19. The effort of a Porter governor is equal to (where c = Percentage increase in speed, m = Mass of ball,…
  20. Crowning on pulleys helps
  21. According to Kennedy's theorem, if three bodies move relatively to each other, their instantaneous centres…
  22. Two pulleys of radii r₁ and r₂ and at distance x apart are connected by means of an open…
  23. In a steam engine, the link constitutes a
  24. The natural frequency of free torsional vibrations of a shaft is equal to (where q = Torsional stiffness…
  25. An imaginary circle which by pure rolling action, gives the same motion as the actual gear, is called
  26. The total number of instantaneous centres for a mechanism consisting of n links are
  27. In which of the following type of gear train the first gear and the last gear are co-axial.
  28. If D₁ and D₂ be the diameters of driver and driven pulleys, then belt speed is proportional…
  29. The Klein's method of construction for reciprocating engine mechanism
  30. When the crank is at the inner dead centre, in a reciprocating steam engine, then the acceleration of…